Here is another little stinger should be good for ice fishing this mold is from fat guys fishing .875'' LITTLE BEN.
That's a cool mold Bob just received my stingers from them they make some of the best molds especially like how the sprues are smallest u can make them
S10CHEVY LIKED above post
No I havnt where is it located
on https://www.crappie.com/crappie/diy-...342-core-shot/
The pin size on the stinger will be different I believe I used a finishing nail I will try to post a picture here later on that stinger.
Last edited by snake River; 12-17-2020 at 11:40 AM.
www.bobsjigs.com
Here is a picture with the stingers you'll see the finishing nails across the cavities put your mold back together and shoot it pull it apart take the pain out of the bodies cut the tail portion off and put the bodies back into the mold and shoot your core shot. Depending on the different molds they are the nail size might be different of course you cannot do this with all molds but there are quite a few of them that you can do this with just a lot of trial and error and of course this is very time consuming.