Circular saw. Doesn’t have to be pretty
Sent from my iPhone using Tapatalk
I want y'alls opinion on how you would cut the notches in PVC for an application like this. I want to be able to cut the V notches or angle notches the easiest way possible. Dremmel tool? Small Router? Any other ideas? Thanks
Circular saw. Doesn’t have to be pretty
Sent from my iPhone using Tapatalk
crappiewisdom, Lowellhturner LIKED above post
I would say if you had the tools, a piece of angled steel in a vise heated up red hot with a blow torch then push/melt it through.
cva34, Lowellhturner LIKED above post
I believe id use either the sawzall or angle grinder...
Multi-tool maybe ...Router would be ok but you will be covered with ...Maybe place Router table with blade up..instead freehanding...Like said above I agree hot steel would work great and easy
Use a miter saw. Set your angle to 45° and do one side of the V then set it to 45 ° and do the other. You can use a dremel to finish the end of the slots
Sent from my SM-J327P using Crappie.com Fishing mobile app
Lowellhturner LIKED above post
Maybe a end grinder and a bur bit
Sent from my moto z3 using Crappie.com Fishing mobile app
Drill pilot hole and then cut out with sabre saw
Sent from my VS995 using Crappie.com Fishing mobile app
The trick will be getting both sides to line up just right, unless you oversize the holes to allow some misalignment.
Lowellhturner LIKED above post