Has anyone ever used this stuff for their boat motors? How did you use it? What were the results? Thanks for all the help.
Mike
Has anyone ever used this stuff for their boat motors? How did you use it? What were the results? Thanks for all the help.
Mike
Aquatic Species Removal Engineer.
May God be with you. Keep CALM and STAY ANCHORED with your faith.
I use it because every comment I have seen on it says it is the best thing ever for cleaning fuel systems and improving performance. I thought it would replace Stabil as a stabilizer but I have since learned you need both, One for cleaning and one for stabilizing and protecting against ethanol, if you buy that kind of gas. So far, I've only run non-ethanol, but you never know for sure what you are getting.
My outboards are old, so I need all the help I can get.
Mark 1:17 ...I will make you fishers of men
I put an ounce into every gallon but I don't use much gas as I only have a 9.9. I started using it after reading about he great it was on duckhunter.net
Cubeice thanked you for this post
Its not a engine treatment Mike.....Its a fuel treatment that helps keep the fuel system clean. Its good stuff, been around for years.
I have spent most my life fishing........the rest I wasted.
PROUD MEMBER OF TEAM GEEZER
PICO Lures Field Rep
Has saved me a couple of pieces of lawn equip. that I thought was gone ran some sea foam and they have been running every since great stuff.
PROUD MEMBER OF TEAM GEEZER
I use it in my boat every tank . Also use it in my truck about 2 or 3 times a year . I use gas station gas in the boat .
Mike, it cuts the varnish out of cab,fuel pump and anywhere gas may sit. If you have never run it dose that new motor up pretty good with it and run the snot out of it. Leave it sit in carbs a few days then run it again. Then just add a couple of ounces every time you fill up. Also good to add some Marine Stabil every fill up. Check your motor for a filter under the cowel. If it dosent have one you need to add one between tank and carbs.
Proud Member of Team Geezer
Charlie Weaver USN/ENC 1965-1979
Here ya go, Ship :
http://www.boatingmag.com/maintenanc...ater-separator
http://www.moellermarine.com/afterma.../fuel_filters/
Best case scenario is you can mount the separator between the gas tank & bulb, and only have to cut the fuel line & attach it to the separator. Worse case scenario is you have to move things around, and/or get a longer fuel line, and "make it fit" your boat's bilge area.
I've got one, but haven't gotten around to putting it on, yet ... as my boat presents a possible "worst case scenario".
I have the Moeller Clear Site (#33314-10) 10micron system ... and it's much bigger, in real life, than what the pictures online would indicate. It's almost 10" tall & 5" wide. I researched & went with this one for my 90HP Merc 2strk.
Looks like this :
.... cp
Yes the marine stabil is formulated a bit differently for outboard and marine applications. I happend on a TV show where they were discussing the Stabil products. Up til then I figured they were the same. Won't hurt to use the regular, the marine is just tweaked a little more toward boat appications.
Mark 1:17 ...I will make you fishers of men