Has anyone here tried sharkhide sealer? My new 2008 tracker looks like crap after the summer. Used some oxilic acid to clean scum off, but aluminum still gray. thinking about acid washing and then sealing.
Waterboy1
look thru these threads ... see what you can find : Crappie.com - Search Results
... cp
I am a fiberglass man myself...but I'm also a shop teacher..I agree with canepole...the acid will hurt the anodization. I would not use it...even if you were going to reseal. If it where me I would get some aluminum polish/cleaner...not acidic...a DA sander...put a buffing wheel on it and go to work...being careful not to burn it. I'm sure they make protection products for them. I would think Bass boat saver would work. You can spray it on anything. I use it religiously. After using it, things in the water will no longer stick to my boat. :D I bet if you googled and looked around you could find something that would do the same on aluminum. just my .02 cents...lol
"But if serving the Lord seems undesirable to you, then choose for yourselves this day whom you will serve, whether the gods your ancestors served beyond the Euphrates, or the gods of the Amorites, in whose land you are living. But as for me and my household, we will serve the Lord.” Joshua 25:15
I have done some reading as I would like to know this also...most polishs...even 3M's look like they are not recommended for anodized aluminum. If you loose your anodization you will be okay...but the keeping it clean part will be LABOR intensive from what I have read. I have included some links of interest that I have found you may want to check out.
aluminum boat cleaning - iboats Boating Forums
Aluminum Pontoon Cleaner for pontoon boats
http://www.lorin.com/PDFs/Cleaning_&...d_Aluminum.pdf
Soderbloom's Online Store - HULL BOTTOM CLEANER
The Aluminum Boat and Repair Board
Cleaning
have read about this in a few places and seems to work well
Bar Keepers Friend Product Line--Including Bar Keepers Friend Liquid: Cleaning Supplies,(www.barkeepersfriend.com)
hope this helps...I would like to know what you end up coming up with. good luck!
"But if serving the Lord seems undesirable to you, then choose for yourselves this day whom you will serve, whether the gods your ancestors served beyond the Euphrates, or the gods of the Amorites, in whose land you are living. But as for me and my household, we will serve the Lord.” Joshua 25:15
The crappie don't care if the boat is shiny.
MO
Go to the store, and get some Soft Scrub. Take a 5 gallon bucket,set on it, elbow grease, and have at it. Not that bad. Good luck Doug
METALL Aluminum Metal Polish. Thats what is used on unpainted aluminun air craft. I used it on my tracker and it cleaned the boat and gave the boat a slick finish, but not a shine from water line down.. May need more elbow than I had.
EJL
If you spray it with any acidic cleaner(aluminum cleaner or wash), it will change the shine to a gun metal gray. Don't do it. Mother's polish will do wonders but it's all elbow grease. Good luck.
Amateur Chaser of Those Thump Thumps to
Raise Those Hand Kandys!
IG: Krappie Krane
I found the perfect solution. My Tracker had this problem when it was new as well. All I have done is keep it for 10 years and it don't bother me no more. :D It did when it was new though.
DP
I am a heterosexual male. 2 Chronicles 7:14
"If my people who are called by My name will humble themselves and pray and seek My face and turn from their wicked ways, then I will hear from Heaven and will forgive their sin and heal their land."