Likes Likes:  0
Thanks Thanks:  0
HaHa HaHa:  0
Results 1 to 3 of 3

Thread: Transducer mounting on a Minnkota PD

  1. 07-21-2007, 11:23 AM #1
    Barnacle Bill's Avatar
    Barnacle Bill
    Barnacle Bill is offline Super Mod and 2014 Crappie.com Man of the Year * Crappie.com Supporter
    Join Date
    Apr 2004
    Location
    Chesapeake, Va
    Posts
    20,379
    Post Thanks / Like

    Default Transducer mounting on a Minnkota PD


    This is the best I've seen so far.
    Fair Winds and Following Seas

    Bill H. PTC USN Ret
    Chesapeake, Va

    Reply With Quote Reply With Quote
  2. 07-21-2007, 07:19 PM #2
    ShilohRed's Avatar
    ShilohRed
    ShilohRed is offline Crappie.com Legend
    Join Date
    Nov 2004
    Location
    Adamsville Tn
    Posts
    4,630
    Post Thanks / Like

    Default

    You can also add shower curtain hangers along the shaft and they will hole the cable along the shaft . And keep if from handing up.
    Pete

    http://www.wildwolfproducts.com/
    Reply With Quote Reply With Quote
  3. 07-24-2007, 08:25 AM #3
    mmjokerr
    mmjokerr is offline Slabmaster II
    Join Date
    Dec 2006
    Location
    Hendersonville Tn
    Posts
    174
    Post Thanks / Like

    Default tranducer mounting

    Well went ahead and bought the new PD/AP with the co-pilot. Does any one have pictures of mounting the transducer to the new PD without the grip n glide handle? I am more concerned about the cable routing part of this equation. I am worried that every time I deploy my motor the transducer cable is gonna get pinched and fray eventually in the pivot area of the motor. So far this is the only draw back I can see of the minn kota motors. My old motor guide was never an issue with this
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

BACK TO TOP