using the rod tip to spear,poke, punch or push a jig that is hung is never recommended . It's much wiser to pull the line till it breaks off . Not only is it wiser but much more cost efficient . A dollar jig or chance of breaking a tip ? Easy math.
Perhaps a stupid question,but never the less,here goes.I have a pretty good variety of fishing rods,but I really enjoy fishing with the simplicity of telescoping rods,and no reels.I usually set them up with 4-6 lb test,with the line length matching the rod length.
I've been hesitant to reach into brush much for fear of snagging my jig and not being able to free it.I don't mind losing jigs,my fear is snapping the tip on my extention pole,because I snagged where I couldn't reach my rod tip to grab the line.
Other than rigging my jigs to prevent as many snags,how does anyone else free themselves without breaking the fragile rod tips?Another scenario would be snagging in shallows where it was impossible to reach the line at the rod tip to pull the lure free or break the line.
using the rod tip to spear,poke, punch or push a jig that is hung is never recommended . It's much wiser to pull the line till it breaks off . Not only is it wiser but much more cost efficient . A dollar jig or chance of breaking a tip ? Easy math.
I never tie the line directly to the eye. I run it thru the eye then tie the line to the pole. If you get hung up pull straight back and you will never break the eye off.
I don't either, Bill. I run the line thru the eye and loop it around the eye a couple of times and then spiral wrap it around the pole, starting right behind the tip eye and going all the way down to near the butt end of the pole. Not only does that keep from snapping the tip off, but it also allows you to break off some line and not have to re-string the whole pole. You just un-tape or untie the line from the butt end of the pole and pull out however much line is needed to get back what you lost.
Did that on my 10' & 12' collapsible poles that I used to dip a minnow/float down into the "buck brush" at Barkley Lake. Poles were strung with 17# test Cortland braid with a 12" leader of 8lb test mono. Although, I really don't remember ever breaking the leader, or getting hung bad enough to have to try and pull it free.
lugnutzz thanked you for this post
I use 10' B&M telescopic poles with 14# red cajun line tied straight to the eye on the poles. When I get hung up I take a rag wrap it around hand and line to keep from cutting hand. Then just pulling the line and straightening out hook. Then take needle nose plyers and reshape hook and so far the wife and I use 12 poles(6 each) and never have broke an eye or pole.
Be safe and good luck fishing
Thanks guys,sometimes the simplest solutions escape the sharpest minds..........that's probably why it escaped mine
I use heavier jig poles like Ozarks and 1/8 oz jigs . The heavier jigs easier to shake free . I do use the rod to knock my jigs loose if that don't work , just use care not to force it . Light weight rods of other brands I have used bad were about breaking .
Moderator of Beginners n Mentoring forum
Takeum Jigs