Tebo Success and trouble

[MinnowDipper]

Got on the water about 2:30 dink dink dick dink dink keeper and so on all was going great 6 eaters then trolling motor started acting up, pulled out and headed home early. Caught all the keepers rigging or dipping with double rig with an 1/8 oz slabalious on bottom no minnow and a minnow about 12 inches above it. Tried double minnow rig but all they did was to caught double dinks.

Sent from my SAMSUNG-SM-G890A using Tapatalk

[MinnowDipper]

In case your counting I picked up another at the boat ramp from a nice gentleman who didn't want to clean one fish!

Sent from my SAMSUNG-SM-G890A using Tapatalk

[ripnlips]

Looks good to me Jim. What is the trolling motor problem?

[MinnowDipper]

the rod that holds the blade comes out too far making a heck of a noise when you run. I took it apart and reassembled it this morning works better but probably time to start a trolling motor fund

Sent from my SAMSUNG-SM-G890A using Tapatalk

[Lil Baby]

the rod that holds the blade comes out too far making a heck of a noise when you run. I took it apart and reassembled it this morning works better but probably time to start a trolling motor fund

Sent from my SAMSUNG-SM-G890A using Tapatalk

Had the same problem when my sheer pin got bent I had to hammer the prop off

[MinnowDipper]

I think I found the broken part, the part along with new seals and o-rings comes to $8.64 but to ship it here in time to go fishing next weekend set me back another $14.94. Oh well if it works much cheaper than a new one.

[beagle man]

if things did not go wrong it would not be fishing.

[long poler]

Nice report.
Good to hear from the Tebo

[ridgerunner200]

Not that it means much now that it seems you might have your problem fixed. But these guys are pretty good and inexpensive have taken mine to them a couple of times to get rebuilt usually have them done in a couple of hours if you call ahead Reliable PWC marine (573)-873-9994 282 N 7 Hwy Camdenton MO 65020