I made the entire setup from T-post to rod holders.
I am looking for ideas to make rod holders for my boat.
I like fiddling around, tinkering with the boat and would like to make rod holders rather than buy them.
Please show your HOME MADE ROD HOLDERS.
Thanks
Squall Line
Politicians should be required to wear their corporate sponsors uniform like NASCAR !
I made the entire setup from T-post to rod holders.
THAT LOOKS REALLY GOOD AND WELL DESIGNED!
I wonder how you made the center post? It looks like square tube with a stud in the center.
Politicians should be required to wear their corporate sponsors uniform like NASCAR !
On the front I used 1/2" upright, cross bar is 3/4" with a reducer T and 3/4" pipe hangers and a 1/2" floor flange. Screw it on & off as needed. On the sides the picture kinda explains itself.
THE BEST TIME TO FISH IS WHEN IT'S RAINING AND WHEN IT'S NOT RAINING
This is my old redneck pole troller, now it is not fancy but it works good for me. I have $35.00 in it, I bought a stick of square tubing and I had some scrap PVC pipe laying around the shop to make the holders for the poles. I used some PVC caps to make a holder on each side for a jar of crappie nibbles and I have my fish finder mounted at eye level so I can watch it and my poles at the same time. I know it is not the best but it works.
Juiced Up Baits Pro Staff
K2 Coolers Pro Staff
Mike's Custom Crappie Jigs Pro Staff
Juiced Up Baits Pro Staff
K2 Coolers Pro Staff
Mike's Custom Crappie Jigs Pro Staff
Here's some I made from 6" PVC
This is what I dipped them in.
[/QUOTE]
WALLY MARSHALL PRO STAFF
CATCHIN' CRAPPIE GUIDE SERVICE
CREEKS ROD TRANSPORT RACK
870-307-2572
www.podunkideas.com <--Click here
------------—————
https://www.crappie-gills-n-more.com/
https://cornfieldfishinggear.com/
------------------------>> Pro Staff Sonar Advisor