Quick Injection Question
I received some stuff today and began to look at my new equipment and came up with a few questions. I have a 2 piece aluminum mold and a small injector. The mold port small hole diameter is about 5/16 inch and the nozzle on the injector is about 1/4 inch. They don't fit snug and I assume they shouldn't, am I correct? I am really new to this and don't want any hot plastic to shoot out all over the place especially on me. When prepping, should I put anything on the mold itself to prevent sticking or making for easy removal of the bait? What about the O-Ring on the injector, should it be sprayed with some type of lube? I have some plastic from Bear Baits (CPC-2101 Soft) and was planning on using a small pot to heat in, will there be a lot of fumes? How dangerous is using this plastic (fume wise)? Thanks for any replies with advise.
"Insanity is inherited, you get it from your kids."
Mike Epperson