Older set ups used carpet covered bunks turned up on edge to match the angle of the side of the boat
Any recommendations for trailer guide ons? Post, rollers, bunk boards? Scared of cheap stuff, even though I don’t plan on ramming into them. Boat is white aluminum-FYI.
Older set ups used carpet covered bunks turned up on edge to match the angle of the side of the boat
The love for fishing is one of the best gifts you can pass alongreeltrick thanked you for this post
I put the Guide on boards on my trailer for a 1860, got them at academy sports,I bought 8’ treated 2x4s so I could cut to the length I needed and carpeted them, have them adjusted tight so boat lines up perfect every time, makes it easier for one man opp.
I put the roller type post on my 1548 tracker, couple yrs ago, should’ve went with the guide boards,
Sent from my iPhone using Crappie.com
Hello : I put C E Smith 60" lighted guide posts on my trailer a few years ago. Now I wouldn't have a trailer without them. Great for backing up your empty trailer on steeper ramps especially at night , lets you know exactly where your trailer is. Also adds extra lights when traveling. Also added bow guide ons. I have an aluminum v-bottom boat and they center the boat perfectly on the trailer. You didn't tell us what kind of boat you have . Hope this helps you. Good Luck. O - R
I do the same as outdoorsron.
C E Smith 60" lighted guide posts also. Easy to install and really tough.
Sent from my SM-T580 using Crappie.com Fishing mobile app
armyman LIKED above post
Also added bow guide ons. I have an aluminum v-bottom boat and they center the boat perfectly on the trailer.
outdoorsron
Have a picture or link to the bow guides you added to your trailer for the V bottom?
Thanks
Thanks everyone. I’ve got an 1860 and if I’m off a couple inches the transducer gets in the way. I’ve had bunk boards with different boats but didn’t know how rollers and posts would be. Rollers I think would be best, but don’t want black marks all over the boat. Posts seem like they are just visual help, not so sturdy.
Thanks everyone. I’ve got an 1860 and if I’m off a couple inches the transducer gets in the way. I’ve had bunk boards with different boats but didn’t know how rollers and posts would be. Rollers I think would be best, but don’t want black marks all over the boat. Posts seem like they are just visual help, not so sturdy.
Bstinnett
If you want a dead on load with the boat you may want to consider a pair of these guides.
Installed a pair for a 20ft fiberglass walleye boat that sometimes loaded off center on the bunks at the rear depending on the ramp conditions.
After pulling the boat, I would have to put my shoulder into pushing the boat over to drop the boat strakes into alignment with the bunks at the rear end.
Total PIA as it is a heavy boat.
A little pricey but have not missed a load or needed to push the boat into alignment in the past 2 seasons.
Bullseye Quick Load - Self Centering, guide-ons, loaders - Welcome to BullsEye Quick Load
YouTube
Good Luck