Buy a fishing boat
It would take some fabricating, but I'm guessing you could put Hi-Tek type mounting plates vertical on the 4" vertical lip that goes around the boat. The rod holders themselves would need to cant out and up and run along the side of the boat. The holders themselves would drop in and when they weren't in use the only thing left on the boat would be the mounting plates, and they would be out of the way for the most part. With a lot of measuring, it would keep them fairly close to the boat and side of the wrap around windshield.
The downside to this is your rods would hang over the water. I don't see an immediate way to get around that, though.
Lose the windshield
MEMBER CRAPPIE MAFIA
Dudes,,, It was a gift from my father in law,,,, Buying another boat would bring bad Mojo,,,, she's a very nice boat and with the windscreen, It keeps me out of the wind when your freezing your arse off,,,,lol....
It's a pain, but you could just break them down and put elastic straps on them. They sell some good ones at southern pro. Or what about something to point them straight up, like used in a center console boat.
Team Overalls Travel Squad
FISH for LIFE
HUMANKIND......be both
How many rods are you going to be storing? is your concern more for storing while on the water or while in route to and from water?
Three can keep a secret................If two of them are dead! (Benjamin Franklin)
Mid. Enroute mainly...once I'm there I'll be using them most days,,,
Ranger boats
Perotti pro holders
Avery outdoors superstore
A society grows great when old men plant trees whose shade they know they shall never sit in.
Greek Proverbcanebreaker LIKED above post
Just an idea.
Place a bar of clips along the windshield for the front of the rods. A removable T post support in the rear of the boat for rod support.
Everbilt 17 in. Wall-Mounted Spring Storage Clip Bar-01147 - The Home Depot