Thread: HiTek rod holders repalcing with knobs

here is the new spider rig setup..finally got the right knobs and it works great..here are the specs for hardware i got from FASTENAL:
Knobs: Part # 11106464
2" set screws for rod holders part # 73284
1 1/2" set screws for base and t-bar part # 73282

Only problem I had was screwing to the base..I put some Loctite thread sealer on so knob is sealed to threads and it works great. The knobs on rod holders and t-bar DO NOT need Loctite as they fasten down tight.. Hope this helps.

thanks,looks good

Originally Posted by lhumphre

here is the new spider rig setup..finally got the right knobs and it works great..here are the specs for hardware i got from FASTENAL:
Knobs: Part # 11106464
2" set screws for rod holders part # 73284
1 1/2" set screws for base and t-bar part # 73282

Only problem I had was screwing to the base..I put some Loctite thread sealer on so knob is sealed to threads and it works great. The knobs on rod holders and t-bar DO NOT need Loctite as they fasten down tight.. Hope this helps.