Rod Holders and Double Seat Mounts

[the crappie soldier]

2, 3, and 4 rod holders available in various heights and drop in Double Seat mounts. Rod holders and T-bar fully adjustable to any direction. Quick detach base allows for removal in seconds for relocating, trailering covering boat, etc. All aluminum with stainless steel hardware. Work great for tightlining, trolling cranks, etc.

Check website or call for pricing: Cumberland Crappie Custom Rod Holder Home
or phone (606) 425-1751.

Free shipping via USPS. Thanks for looking, tight lines!

[the crappie soldier]

No tools needed for adjustment. Once the base plates are mounted in your boat you won't need any tools or wrenches to make adjustments to T-bar or each rod holder--on or off the water. No tools required to remove the T-bars either. Adjustment knobs only need to be hand tightened to hold where you put them. Adjust T-bar and each rod holders 360 degrees, in 7.5 degrees increments.

[the crappie soldier]

Double seat mounts photos on Skeeter bass boat. There are a couple more pictures on the website too. Mates tight to the base in your boat and stays put. Have towed many miles on the highway/interstate with this mounted in the boat and it don't move. But if you want to take it out thats easy too.

Width is custom ordered so you can have more elbow room in between seats or narrow enough so you can open rod lockers if your using on a bass boat, thats up to you, mine is 27" wide and no problems fishing or opening rod boxes. Please call with measurements before you order and to confirm seat post size.

Cost is $125-$150 depending on the size of your seat posts. Rangers, tritons and some others have larger diameter posts/bases. Most boats have standard 3/4 pin.

These are a HOT item right now. Give us a call. Thanks, tight lines everybody.

[cajun fryer]

Were do you get the actual rod holder?

[Quackrstackr]

Do those seat mounts bend or is there some sort of bump stop underneath to keep them from bending down to the deck height?

[the crappie soldier]

Were do you get the actual rod holder?

The rod holders are made in Ky, you can order them on the website Cumberland Crappie Custom Rod Holder Home

[the crappie soldier]

Do those seat mounts bend or is there some sort of bump stop underneath to keep them from bending down to the deck height?

Quack, they don't bend, might flex a little bit when your sitting on them if your floor aint level but they don't bend. If you need it curved a little to sit on the deck that can be done. I know some were done that way for a G3. Give Terry a call 606 425-7151 if you need specifics for you boat. Tight lines.

[the crappie soldier]

These are some better pics that were taken today. You can see the rod transport rack in these photos too. That rod rack aint on the website yet but call if you're interested.

Tight lines.

[the crappie soldier]

Made a typo on the phone number in the first post.sorry.
it should be
(606) 425-7151

[the crappie soldier]

A lot of cdc'ers have asked about the rod transport rack thats in some of the photos above. Its $200 and not on the website, complete custom order so can be made a little taller/wider, whatever you need and would take a couple of days to make. All 3 sections/stands will come with our bases to mount in the floor and racks can be removed when you don't need them on the boat. Thanks for looking, tight lines!

Call for more info.