SLABSAUCE Fish Attractant |

Search:

Type: Posts; User: sliderman; Keyword(s):

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    23
    Views
    1,031

    The missing tooth is the result of what's...

    The missing tooth is the result of what's referred to as a single stress overload. It's the tooth that was in full contact at the instant the prop hit a solid object with the engine was at speed. A...
  2. Replies
    8
    Views
    402

    If you checked the orange wire with a meter, you...

    If you checked the orange wire with a meter, you might have a weak power connection at the fuse block. Will show voltage with no load but not enough current to operate pump. Check voltage again and...
  3. Replies
    8
    Views
    402

    Switch will work without light. Is that a 2...

    Switch will work without light. Is that a 2 position switch or 3?
  4. Replies
    8
    Views
    402

    Light is probably burnt. It requires a ground...

    Light is probably burnt. It requires a ground connection on the switch to have light operation.
  5. Thread: prime bulb

    by sliderman
    Replies
    15
    Views
    733

    Yamaha and tohatsu have the best primer bulbs on...

    Yamaha and tohatsu have the best primer bulbs on the market in my opinion. The marpac brand blue primer bulbs are good quality too.
  6. Replies
    7
    Views
    359

    Vent the tank.

    Vent the tank.
  7. Replies
    7
    Views
    349

    You have issues inside the lower unit if you are...

    You have issues inside the lower unit if you are looking for that much adjustment to bring it back into service. The linkage shouldn't require adjustment once it's set correctly. At some point, if...
  8. Replies
    3
    Views
    235

    It sounds like you are describing a control box. ...

    It sounds like you are describing a control box. If the boat has a steering wheel, the neutral safety switch you are looking for is in the control box.
  9. Replies
    18
    Views
    450

    You have two water pumps. The automotive style on...

    You have two water pumps. The automotive style on the front of the engine and an impeller that is located on top of the lower unit, half way up the outdrive. You will need to disconnect the exhaust...
  10. Replies
    18
    Views
    450

    The engine will pass anything that can get passed...

    The engine will pass anything that can get passed the exchanger. If it's clear, your problem is in the outdrive or head.
  11. Replies
    18
    Views
    450

    345974 Top of bell housing. Will be smaller...

    345974
    Top of bell housing. Will be smaller than the one in the pic. Inside is a honeycomb network and catches a lot of debris. If you shredded the impeller, it will be stopped up. Pull hose off...
  12. Replies
    18
    Views
    450

    Ok. You've got several 'possibles' in play. I...

    Ok. You've got several 'possibles' in play. I would inspect the following, 1) water pump base. 2) The plastic housing that the copper tube plugs into (that's located in the upper housing of the...
  13. Replies
    18
    Views
    450

    Ok, did you melt the first impeller or did it...

    Ok, did you melt the first impeller or did it come apart?
  14. Replies
    18
    Views
    450

    Is your boat equipped with power steering?

    Is your boat equipped with power steering?
  15. Replies
    15
    Views
    413

    No. The port is cross drilled in the bottom of...

    No. The port is cross drilled in the bottom of the carb
  16. Replies
    15
    Views
    413

    Yes. There's a connecting port from the bowl to...

    Yes. There's a connecting port from the bowl to that location.
  17. Replies
    15
    Views
    413

    That's a sure sign that there's an issue with the...

    That's a sure sign that there's an issue with the needle and seat. I have on many occasions seen where a freshly assembled carb would display the same issue. Before you pull it off, loosen the...
  18. Replies
    5
    Views
    277

    Trim the motor up and look at the top of the tilt...

    Trim the motor up and look at the top of the tilt ram. Just to the side of the connection point, you will see a component with a wire ran to it. That's it. On OMC products, it sits inside the...
  19. Replies
    5
    Views
    277

    The trim sender is adjustable by means of the two...

    The trim sender is adjustable by means of the two fasteners in their slotted holes.
  20. Thread: Kill switch

    by sliderman
    Replies
    5
    Views
    328

    You mentioned that you changed the switch out. ...

    You mentioned that you changed the switch out. There is a universal kill switch on the market that can be wired either "normally open" or "normally closed". There are 4 prongs on the back of the...
  21. Replies
    11
    Views
    857

    Sold, please close.

    Sold, please close.
  22. Replies
    11
    Views
    857

    It's a 2014 model

    It's a 2014 model
  23. Replies
    11
    Views
    857

    I can't say it's exact age. It came off of a...

    I can't say it's exact age. It came off of a 2011 model boat. At some point, the lower housing has been replaced and whoever did the repair, did not engrave the model number. Without that, I can't...
  24. Replies
    11
    Views
    857

    Works like it should. Installation available.

    Works like it should. Installation available.
  25. Replies
    11
    Views
    857

    I think I'm going to pass on the H5. I've...

    I think I'm going to pass on the H5. I've currently got a 5si and 7si. Looking to replace the 5 with something bigger. Going to try to keep the sale local.
  26. Replies
    4
    Views
    363

    Is the comment about the top two cylinders a...

    Is the comment about the top two cylinders a figure of speech or a known fact?
    Was the computer reading a static reading or dynamic on the water?
  27. Replies
    11
    Views
    857

    No bites on a trade so I'll let it go for $800.

    No bites on a trade so I'll let it go for $800.
  28. Replies
    15
    Views
    1,378

    The short 'peak' cycles around here are directly...

    The short 'peak' cycles around here are directly related to the fishing pressure / lake size ratio. NEA has a much larger fisherman base than it does water.
  29. Replies
    15
    Views
    1,378

    I agree.

    I agree.
  30. Replies
    11
    Views
    857

    No, no price set. Looking to trade it at this...

    No, no price set. Looking to trade it at this point.
Results 1 to 30 of 100
Page 1 of 4 1 2 3 4

BACK TO TOP