SLABSAUCE Crappie Attractant |

Search:

Type: Posts; User: TheGrandPoohBah; Keyword(s):

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    3
    Views
    668

    You could call that move as "The drive thru at...

    You could call that move as "The drive thru at the crappie hotel". :)
  2. Replies
    14
    Views
    701

    Tip: "Always replace the ferrule".:cheers2

    Tip: "Always replace the ferrule".:cheers2
  3. Well, that explains why they are still out of 3...

    Well, that explains why they are still out of 3 ton jack stands at Harbor Freight. I went there on July 4th and picked up some wire looms and flap discs, but they were out of jack stands. My my.
  4. Replies
    14
    Views
    701

    I would spray it with AeroKroil, let is soak...

    I would spray it with AeroKroil, let is soak overnight, and take it apart the next day.
    Are you referring to the bleed/check valve system identified here as items 10, 11 and 16?
    Cylinder Block &...
  5. Replies
    10
    Views
    447

    If it is not thru the fiberglass and is only...

    If it is not thru the fiberglass and is only surface, and you don't want it "Really Noticeable", buy a bottle of touch up paint in the closest match color you can find. Take a pic of the color and...
  6. Replies
    11
    Views
    609

    Very nice.

    Very nice.
  7. Replies
    7
    Views
    538

    How about a fishing float just big enough to do...

    How about a fishing float just big enough to do the job?
  8. Replies
    15
    Views
    890

    Probably wouldn't hurt to unplug the fuel line...

    Probably wouldn't hurt to unplug the fuel line when you park it, or install a fuel cutoff switch.
    I would not be happy to just "Accept it as the way it is", no no.
    That issue happens on occasion...
  9. Replies
    14
    Views
    677

    AND - check for circuit protection. It is...

    AND - check for circuit protection. It is possible that it failed, or needs one now.
    On a side note, I highly recommend battery disconnects to easily shut off all power for any reason you want to,...
  10. Replies
    14
    Views
    677

    By all means, I highly recommend you change the...

    By all means, I highly recommend you change the stator with a CDI model, and change the rectifier also.
    Look on Amazon and Ebay, the stator can be found for less than $200, and the rectifier for...
  11. Replies
    6
    Views
    252

    Why not go ahead with new bearings, seals, and...

    Why not go ahead with new bearings, seals, and the grease?
    Better yet, new hub kits...
  12. Thread: Neely

    by TheGrandPoohBah
    Replies
    9
    Views
    653

    Good times! Not to hijack, but I have some lip...

    Good times!
    Not to hijack, but I have some lip grippers just like those, 3D printed and they float. Can't beat that!
  13. Dash cam and pack heat. Crazy times, for sure....

    Dash cam and pack heat.
    Crazy times, for sure.
    Also advise you reduce going out and about after dark. Try to get 'er done during daylight hours, especially in cities.
  14. Good report. I too have started with "A Mess" as...

    Good report.
    I too have started with "A Mess" as my limit.
    If I need more than that, I just go more often!
  15. Replies
    13
    Views
    997

    Sounds like some carb work is probably in order. ...

    Sounds like some carb work is probably in order.
    I highly recommend you run fuel stabilizer in your boat all the time at the recommended mix, regardless of type of fuel. I use Mercury Quicksilver...
  16. Replies
    14
    Views
    723

    Have you considered fabricating a little wheel...

    Have you considered fabricating a little wheel for the foot of the motor? rotfl
  17. Great video, thanks for posting!

    Great video, thanks for posting!
  18. Replies
    5
    Views
    302

    Connect a known good digital meter to the...

    Connect a known good digital meter to the cranking battery set to "Volts". Note how in your current condition, the volts are dropping. Remove items one at a time until the volt drop stops - in fact,...
  19. Replies
    15
    Views
    1,088

    Well done, good report.

    Well done, good report.
  20. Make sure plates are covered, but not so high...

    Make sure plates are covered, but not so high that it bubbles over on top of the battery when charging.
    Allow room for expansion.
    Remember to add only distilled water into the battery - but...
  21. Replies
    31
    Views
    72,986

    Sticky: When I replaced my trailer hubs, the new Smith...

    When I replaced my trailer hubs, the new Smith hubs each came in cute little black plastic cases. I kept the better one of my old hubs, put it in one of the little cases (Including lug nuts, old...
  22. Replies
    7
    Views
    324

    Put the meter to it and find where the voltage...

    Put the meter to it and find where the voltage stops.
  23. Replies
    25
    Views
    1,391

    May I suggest "Bofum". (Borrowed that term from...

    May I suggest "Bofum". (Borrowed that term from an old buddy of mine).
  24. Thread: Thanks

    by TheGrandPoohBah
    Replies
    5
    Views
    675

    This goes up here every year for the Uncle who...

    This goes up here every year for the Uncle who never came home.
    This Holiday is for those who gave all. You cannot give more than that.
    "Honor And Remember".

    376399
  25. Replies
    25
    Views
    1,391

    Sorry no help with the threads, but might as well...

    Sorry no help with the threads, but might as well get 2 of 'em, use one and stash the other.
    For those with rubber lined ones, be sure to twist and tighten if needed. Without good resistance when...
  26. Replies
    16
    Views
    1,317

    Good catch. I remember that was the fish we ate...

    Good catch.
    I remember that was the fish we ate the most as I was growing up.
    I remember Mother would clean and save milk cartons so that when we went fishing, we would come home and clean 'em like...
  27. I hear ya! Looks like until I get some more jack...

    I hear ya!
    Looks like until I get some more jack stands, I will be using the old "Tried and true" wooden blocks of all assorted sizes.
    I am yet to hear of any recalls on red oak!:biggrin
  28. Another point - The recall mentions "...pawls...

    Another point - The recall mentions "...pawls that could "disengage from the extension lifting post" under a shift in weight, causing them to suddenly collapse". On mine the "Extension Lifting Post"...
  29. Here are mine and what they look like, item...

    Here are mine and what they look like, item 61196.
    Three ton, gray and black, with the box and number.
    Might take them back Monday while a big sale is going on.
    376127376128
  30. Replies
    18
    Views
    3,644

    What's not to love about it? Sounds great!

    What's not to love about it? Sounds great!
Results 1 to 30 of 100
Page 1 of 4 1 2 3 4

BACK TO TOP