SLABSAUCE Crappie Attractant |

Search:

Type: Posts; User: Snubby; Keyword(s):

Page 1 of 4 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    18
    Views
    750

    I am, I could easily swap my setup over to a 24...

    I am, I could easily swap my setup over to a 24 volt system wiring my batteries in a series. After looking into it Garmin says you can use up to 32 volts. Until I see it for my own eyes on someone's...
  2. Replies
    23
    Views
    1,628

    That's for sure, let the least of capable among...

    That's for sure, let the least of capable among us gather a meal. The drums been tuned, but national knowledge is ever so sweet or much less solemn. Told ya so!
  3. Replies
    18
    Views
    750

    Just read your earlier response about running...

    Just read your earlier response about running scope and gls10 on 24volts for better resolution or return. I think your misinformed, I do run two designated Dual Cranking 24's in parallel to maintain...
  4. Replies
    18
    Views
    750

    Simple buy two small 24 volt lithium's and keep a...

    Simple buy two small 24 volt lithium's and keep a one conventional 12 volt battery for cranking. Less space taken up but at much higher cost. What you trying to power that would require two 24v feeds...
  5. Replies
    23
    Views
    1,628

    Looks like a promising first outing, congrats!...

    Looks like a promising first outing, congrats! What in tar-nation are the 3 fish in the upper right corner, big gizzard shad? :scratchhead
  6. Thread: Prop

    by Snubby
    Replies
    1
    Views
    237

    Don't rule out Raker props, got a few old school,...

    Don't rule out Raker props, got a few old school, one new and or two original. 24 P works well, got one new with adjustable vent settings. Not sure with crossovers and or compatibles, but wouldn't...
  7. Thread: Pressure Washer

    by Snubby
    Replies
    25
    Views
    1,962

    Nice! Glad to see the shipper was able to get it...

    Nice! Glad to see the shipper was able to get it to you in one piece this time. You will enjoy that Simpson for sure. Looking at design make sure your careful if ever loading it or unloading it the...
  8. Thread: Arkabulta

    by Snubby
    Replies
    5
    Views
    676

    With the 5 - 10 SSE winds forecast for tomorrow...

    With the 5 - 10 SSE winds forecast for tomorrow then Bayou Point or Kelly's Crossing would be two good ramps to use. Good luck, and keep an eye on the weather. Calling for scattered t'storms in the...
  9. Replies
    12
    Views
    1,029

    Wasn't passing judgment by any means. I'm hoping...

    Wasn't passing judgment by any means. I'm hoping the setup works well for you and the misses! Hopefully you didn't find my comment as derogatory or belittling. I understand we all start from...
  10. Replies
    12
    Views
    1,029

    Nice gear, I know you will enjoy the terrova....

    Nice gear, I know you will enjoy the terrova. Just hope the lithium battery holds up to pulling cranks at 1.5 to 2 mph for 6 to 8 hours a day. If it does and with charge cycles boasted as advertised...
  11. Replies
    25
    Views
    1,960

    My guess, water temps are still a little cool for...

    My guess, water temps are still a little cool for crappie to chase a crankbait down and slam it. You can try slowing down a bit to 1.3 to 1.5 and see if that helps. Once they get in the mood you will...
  12. Replies
    55
    Views
    5,077

    Poll: I caught lots more fish before livescope. I find...

    I caught lots more fish before livescope. I find myself enthralled in the screen now and or the behaviors of other fish. In a nutshell, I spend more time looking at screens then I ever did actually...
  13. Replies
    2
    Views
    563

    Any other pictures other than just the base of...

    Any other pictures other than just the base of pole? Like how you had it mounted, overall length and handle used to swivel the pole? Looks like you used a ram mount for the livescope transducer, but...
  14. Replies
    17
    Views
    1,482

    One epidemic at a time wannabe. I've seen enough...

    One epidemic at a time wannabe. I've seen enough hand shots to make me less inquisitive about faces, not to mention feet. Some folks around with beat up appendages for sure. Nah, think it be a long...
  15. Replies
    11
    Views
    645

    Yes sir, buy you a spool of 1500 yards power pro...

    Yes sir, buy you a spool of 1500 yards power pro hi viz yellow in 40 / 10. Think I paid $120 or so 2 years ago. I spooled 12 ats 15's a jig pole spinning reel and a few low profile baitcasters and...
  16. Replies
    12
    Views
    338

    Happy Birthday! Hope you had a good one. Sent...

    Happy Birthday! Hope you had a good one.

    Sent from my SM-G892A using Tapatalk
  17. Thread: Good one

    by Snubby
    Replies
    10
    Views
    729

    That's a nice one for sure congrats! Sent from...

    That's a nice one for sure congrats!

    Sent from my SM-G892A using Tapatalk
  18. Replies
    7
    Views
    955

    I prefer getting a good night's rest and being up...

    I prefer getting a good night's rest and being up a couple of hours before sunrise and setup fishing before first light. Can avoid the mid day heat as well as the pleasure boating crowd. I bet it...
  19. Replies
    21
    Views
    1,377

    I agree with above poster's. You will save very...

    I agree with above poster's. You will save very little trying to tackle that kind of job single handedly or recruiting a couple ne'er do well part time crappie anglers, Lol. Those guy's have the...
  20. Replies
    9
    Views
    627

    A bag of yellow corn meal, flour (optional) a few...

    A bag of yellow corn meal, flour (optional) a few basic household spices and you can mix your own for pennies on the dollar. I'm guilty of buying store bought myself at times, but when forced to a...
  21. Replies
    19
    Views
    1,402

    Spider rigging or pushing out the front I sit on...

    Spider rigging or pushing out the front I sit on the left. Was more convenient for a partner of mine who can't grab minnows with his right hand due to arthritis. And really it doesn't matter much....
  22. You should be fine with an Arkie number 8 hook....

    You should be fine with an Arkie number 8 hook. Works good enough for our fish down here in MS. If hooks are to large for the crankbait body you risk them getting entangled while fishing. I will...
  23. Thread: Pulling Jigs

    by Snubby
    Replies
    10
    Views
    1,082

    When water temps start to warm up and fish get...

    When water temps start to warm up and fish get more aggressive you can usually leave the minnows at the baitshop. I don't really pull jigs and am not crazy about crankbaits. I do pull cranks to stock...
  24. Replies
    10
    Views
    1,246

    Thing's sure have changed alot around that area...

    Thing's sure have changed alot around that area since I was brung up in the 80's and 90's. Heck, schooling and policing were unheard off then for most folks around there. Didn't call it badlands for...
  25. Replies
    11
    Views
    753

    I'm not an expert by any means on livescope, only...

    I'm not an expert by any means on livescope, only had mine 4 months or so. I can say they do use up alot of juice if your using it for more than 3 or 4 hours each outing. I think most prefer a...
  26. Replies
    37
    Views
    2,616

    Back of the truck, there is a picture in this...

    Back of the truck, there is a picture in this thread on page 3 post #23.
  27. Replies
    17
    Views
    1,137

    Back of the unit, mine is the 122sv.373532 ...

    Back of the unit, mine is the 122sv.373532

    Sent from my SM-G892A using Tapatalk
  28. Replies
    37
    Views
    2,616

    I never launch from a ramp hardly, maybe done...

    I never launch from a ramp hardly, maybe done that twice total. And the two ponds I fish I can pull up pretty close to the water, within 50 feet or so easily. If I had to drag it a long way I would...
  29. Replies
    2
    Views
    452

    https://www.crappie.com/crappie/personal-classifie...

    https://www.crappie.com/crappie/personal-classified-ads/407300-triton-ta-196-sale/
  30. Replies
    17
    Views
    1,137

    Have you tried mounting the transducer on the TM...

    Have you tried mounting the transducer on the TM shaft? I had mine mounted on the barrel (port side) at first, It did pretty good. I used the rubber pad they sent with it in between mount and barrel....
Results 1 to 30 of 100
Page 1 of 4 1 2 3 4

BACK TO TOP