SLABSAUCE Crappie Attractant |

Search:

Type: Posts; User: TheGrandPoohBah; Keyword(s):

Page 1 of 4 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    11
    Views
    488

    Very nice.

    Very nice.
  2. Replies
    7
    Views
    503

    How about a fishing float just big enough to do...

    How about a fishing float just big enough to do the job?
  3. Replies
    15
    Views
    781

    Probably wouldn't hurt to unplug the fuel line...

    Probably wouldn't hurt to unplug the fuel line when you park it, or install a fuel cutoff switch.
    I would not be happy to just "Accept it as the way it is", no no.
    That issue happens on occasion...
  4. Replies
    14
    Views
    636

    AND - check for circuit protection. It is...

    AND - check for circuit protection. It is possible that it failed, or needs one now.
    On a side note, I highly recommend battery disconnects to easily shut off all power for any reason you want to,...
  5. Replies
    14
    Views
    636

    By all means, I highly recommend you change the...

    By all means, I highly recommend you change the stator with a CDI model, and change the rectifier also.
    Look on Amazon and Ebay, the stator can be found for less than $200, and the rectifier for...
  6. Replies
    6
    Views
    218

    Why not go ahead with new bearings, seals, and...

    Why not go ahead with new bearings, seals, and the grease?
    Better yet, new hub kits...
  7. Thread: Neely

    by TheGrandPoohBah
    Replies
    9
    Views
    621

    Good times! Not to hijack, but I have some lip...

    Good times!
    Not to hijack, but I have some lip grippers just like those, 3D printed and they float. Can't beat that!
  8. Dash cam and pack heat. Crazy times, for sure....

    Dash cam and pack heat.
    Crazy times, for sure.
    Also advise you reduce going out and about after dark. Try to get 'er done during daylight hours, especially in cities.
  9. Good report. I too have started with "A Mess" as...

    Good report.
    I too have started with "A Mess" as my limit.
    If I need more than that, I just go more often!
  10. Replies
    13
    Views
    943

    Sounds like some carb work is probably in order. ...

    Sounds like some carb work is probably in order.
    I highly recommend you run fuel stabilizer in your boat all the time at the recommended mix, regardless of type of fuel. I use Mercury Quicksilver...
  11. Replies
    14
    Views
    679

    Have you considered fabricating a little wheel...

    Have you considered fabricating a little wheel for the foot of the motor? rotfl
  12. Great video, thanks for posting!

    Great video, thanks for posting!
  13. Replies
    5
    Views
    296

    Connect a known good digital meter to the...

    Connect a known good digital meter to the cranking battery set to "Volts". Note how in your current condition, the volts are dropping. Remove items one at a time until the volt drop stops - in fact,...
  14. Replies
    15
    Views
    1,067

    Well done, good report.

    Well done, good report.
  15. Make sure plates are covered, but not so high...

    Make sure plates are covered, but not so high that it bubbles over on top of the battery when charging.
    Allow room for expansion.
    Remember to add only distilled water into the battery - but...
  16. Replies
    29
    Views
    72,683

    Sticky: When I replaced my trailer hubs, the new Smith...

    When I replaced my trailer hubs, the new Smith hubs each came in cute little black plastic cases. I kept the better one of my old hubs, put it in one of the little cases (Including lug nuts, old...
  17. Replies
    7
    Views
    305

    Put the meter to it and find where the voltage...

    Put the meter to it and find where the voltage stops.
  18. Replies
    25
    Views
    1,370

    May I suggest "Bofum". (Borrowed that term from...

    May I suggest "Bofum". (Borrowed that term from an old buddy of mine).
  19. Thread: Thanks

    by TheGrandPoohBah
    Replies
    5
    Views
    668

    This goes up here every year for the Uncle who...

    This goes up here every year for the Uncle who never came home.
    This Holiday is for those who gave all. You cannot give more than that.
    "Honor And Remember".

    376399
  20. Replies
    25
    Views
    1,370

    Sorry no help with the threads, but might as well...

    Sorry no help with the threads, but might as well get 2 of 'em, use one and stash the other.
    For those with rubber lined ones, be sure to twist and tighten if needed. Without good resistance when...
  21. Replies
    16
    Views
    1,302

    Good catch. I remember that was the fish we ate...

    Good catch.
    I remember that was the fish we ate the most as I was growing up.
    I remember Mother would clean and save milk cartons so that when we went fishing, we would come home and clean 'em like...
  22. I hear ya! Looks like until I get some more jack...

    I hear ya!
    Looks like until I get some more jack stands, I will be using the old "Tried and true" wooden blocks of all assorted sizes.
    I am yet to hear of any recalls on red oak!:biggrin
  23. Another point - The recall mentions "...pawls...

    Another point - The recall mentions "...pawls that could "disengage from the extension lifting post" under a shift in weight, causing them to suddenly collapse". On mine the "Extension Lifting Post"...
  24. Here are mine and what they look like, item...

    Here are mine and what they look like, item 61196.
    Three ton, gray and black, with the box and number.
    Might take them back Monday while a big sale is going on.
    376127376128
  25. Replies
    18
    Views
    3,513

    What's not to love about it? Sounds great!

    What's not to love about it? Sounds great!
  26. Replies
    14
    Views
    651

    Here is the one I went with. At the time, it was...

    Here is the one I went with. At the time, it was a hundred dollar bill.
    I just noticed all kinds of "Clones" all over Amazon - I don't know about those...
    Robot Check
  27. Replies
    7
    Views
    505

    Yes, well done Sir!

    Yes, well done Sir!
  28. I should have mentioned, many may use jack stands...

    I should have mentioned, many may use jack stands like these to support their boat trailers for wheel hub or bearing work, they are very popular as I read somewhere there are about 450,000 sets of...
  29. Immediate Recall On Harbor Freight Jack Stands

    "If you've got a set of Harbor Freight jack stands somewhere in your garage, stop using them immediately because many of them have just been recalled over pawls that could "disengage from the...
  30. Replies
    14
    Views
    651

    No, It's a well thought out design.

    No, It's a well thought out design.
Results 1 to 30 of 100
Page 1 of 4 1 2 3 4

BACK TO TOP