Search:

Type: Posts; User: JayByrd; Keyword(s):

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    9
    Views
    4,784

    If I were patching, I would roughen the surface a...

    If I were patching, I would roughen the surface a little with sandpaper, use the cloth for fiberglass as a mat and use epoxy glue both inside and out.
  2. Three fishermen were fishing when they came upon...

    Three fishermen were fishing when they came upon a mermaid, the mermaid offered them one wish each, the first fisherman said: “double my I.Q” so the mermaid did it and to his surprise, he started...
  3. Thread: LAKE SECESSION

    by JayByrd
    Replies
    18
    Views
    4,697

    I have stayed at the Abbeville Opera House, I...

    I have stayed at the Abbeville Opera House, I would not recommend it in the winter months, the heating was terrible but everything else was fine. The kids do a great job in Greenwood at the Theater...
  4. Replies
    4
    Views
    1,881

    Yes, pin in the upper left of the diagram. I...

    Yes, pin in the upper left of the diagram. I can't see the back side because of the pivot pin.
  5. Replies
    4
    Views
    1,881

    Salvaging Hydraulic Assist for trim

    I bought a 2000 40 Mercury outboard 40ELPTO which had engine problems for spare parts. I want to remove the Hydraulic Assist cylinder from the transom mount assembly. The bottom pin is easy enough...
  6. Replies
    9
    Views
    2,957

    I bought my deep cycle 27 from Wal Mart, it does...

    I bought my deep cycle 27 from Wal Mart, it does fine.
  7. Replies
    23
    Views
    9,453

    Where did you get the umbrella? I need one.

    Where did you get the umbrella? I need one.
  8. Thread: kastking reels

    by JayByrd
    Replies
    24
    Views
    10,315

    I have to come down hard on both of the KK...

    I have to come down hard on both of the KK Sharkys to make the bail reset after casting. Have 3 Okuma's, a Penn, a cheap Berkley and several other cheap spinning reels, they all are smoother than the...
  9. Thread: kastking reels

    by JayByrd
    Replies
    24
    Views
    10,315

    I have 2 KK Sharky III's, would not buy again....

    I have 2 KK Sharky III's, would not buy again. Bail rough closing. Okuma's are smooth.
  10. Info

    I am going to save this article for future reference. I am still learning.
  11. Replies
    8
    Views
    1,963

    What kind of lures work on stripers?

    What kind of lures work on stripers?
  12. Replies
    3
    Views
    710

    I never go on weekends. It's crazy.

    I never go on weekends. It's crazy.
  13. Replies
    10
    Views
    2,189

    All we can legally catch here in SC is 20 per...

    All we can legally catch here in SC is 20 per person, over 8 inches and 30 Bluegill any size.
  14. Replies
    5
    Views
    634

    Saturday

    It was so pretty Saturday, everybody and his brother was out. Nice fish and fun!
  15. Replies
    31
    Views
    4,084

    Seriously, a 15 would be plenty. They are less...

    Seriously, a 15 would be plenty. They are less than 100 lb. And some can be souped up to 20 with a ignition or carb change. I have a 9.5 1967 Evenrude Sportsman on my 14 ft open Starcraft. I can...
  16. That is what I was looking for. Good thing you...

    That is what I was looking for. Good thing you told me to tilt prop down, I didn't know that. Just received the seals. Got them off of E Bay much cheaper than a parts supply or dealer. Most of the...
  17. Thread: Walmart

    by JayByrd
    Replies
    14
    Views
    10,854

    33" wide, that is what I would want for stability.

    33" wide, that is what I would want for stability.
  18. Replies
    16
    Views
    4,156

    I mounted my lights near the top of the loading...

    I mounted my lights near the top of the loading boat guide on the rear of the trailer. They don't get in the water when loading. I used a 3.5" (approx) square galvanized cover for a house wiring...
  19. Replies
    10
    Views
    1,425

    Rode to Riverfork Boat ramp on Summerplace road...

    Rode to Riverfork Boat ramp on Summerplace road and the boat trailer parking was full. Water looks pretty muddy or stained as you say. Nice fish!
  20. Propeller shaft seal replacement 2002 40 Merc.

    I need to replace the foot oil seals on the propeller shaft. The housing just close to the prop has a flange held on by 2 bolts. The motor is a 2002 OT501463. 2 cylinder, oil injection. Do I need a...
  21. Replies
    11
    Views
    2,716

    Good advice, I didn't consider a bad connection.

    Good advice, I didn't consider a bad connection.
  22. Replies
    9
    Views
    4,055

    Yes, in my experience the flats are the best...

    Yes, in my experience the flats are the best eaters. Also they have a big piece of belly meat that is good too. I have weighed the fish and weighed the dressed meat afterwards and I get a higher...
  23. Replies
    11
    Views
    2,716

    I would connect it to the trolling motor battery....

    I would connect it to the trolling motor battery. Mine is. The trolling motor would not draw on the battery as hard pulling down the voltage. Also a trolling battery is made to provide electricity...
  24. Replies
    20
    Views
    3,803

    crappie rod

    ​Berkley Cherrywood HD Spinning Reel and Fishing Rod Combo is $19.25. https://www.walmart.com/ip/Berkley-Cherrywood-HD-Spinning-Reel-and-Fishing-Rod-Combo/43927263
  25. Replies
    5
    Views
    498

    I bought some Ted Ellenbecker Pure Gold Bait...

    I bought some Ted Ellenbecker Pure Gold Bait booster for catfish. Says it is multi species including crappie, hope it will help fill our freezer. May try some Slab Sauce also. Wondering if it is...
  26. Replies
    12
    Views
    6,572

    I like a little turmeric, couple of bay leaves...

    I like a little turmeric, couple of bay leaves for flavor too.
  27. Replies
    1
    Views
    1,168

    I made an adapter out of 1/2 plastic. The adaptor...

    I made an adapter out of 1/2 plastic. The adaptor went on the old holes with countersunk stainless bolts and the new transducer bolted on it.
  28. Replies
    15
    Views
    2,259

    Glad to hear someone fishing at Greenwood, been...

    Glad to hear someone fishing at Greenwood, been watching for awhile. Rabon is real close to me.
  29. Thread: face shield

    by JayByrd
    Replies
    5
    Views
    1,202

    I would think a motorcycle helmet and face shield...

    I would think a motorcycle helmet and face shield would offer protection and also keep your head warm. They are everywhere and all kinds of designs. The Balaclava fleece hoods and ski mask with...
  30. Replies
    40
    Views
    8,532

    Don't forget E Bay, doesn't hurt to look.

    Don't forget E Bay, doesn't hurt to look.
Results 1 to 30 of 59
Page 1 of 2 1 2

BACK TO TOP