Search:

Type: Posts; User: nware14; Keyword(s):

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. Thread: 4 BnM 12' Bgjp

    by nware14
    Replies
    4
    Views
    1,106

    If they are the bgjps with stainless eyes I will...

    If they are the bgjps with stainless eyes I will take them. Pm sent
  2. Replies
    4
    Views
    1,610

    Sold Sent from my iPhone using Tapatalk

    Sold


    Sent from my iPhone using Tapatalk
  3. Replies
    4
    Views
    1,610

    SCR 143 medium tip

    SCR 143 medium tip
  4. Replies
    4
    Views
    1,610

    4 14' Southern Crappie Rods

    I have 4 14' southern crappie rods that I got new last Christmas. I've probably used these rods 10 times. They are nice rods but are just too long for me in my boat.

    $150 shipped - Located in...
  5. Replies
    2
    Views
    1,889

    please close

    please close
  6. Replies
    2
    Views
    1,889

    Drift Master Rod Holder T-118-H For Sale

    For sale Drift Master Rod Holder T-118-H
    About a year old
    75$ TYD
    Located in Central Arkansas
    333046
  7. Replies
    4
    Views
    1,387

    The lake is small compared to the other ones...

    The lake is small compared to the other ones around hot springs. It’s probably the best lake to take a small boat out on. It’s probably the worst fishing out of all the lakes near hot springs as...
  8. Replies
    6
    Views
    946

    If they come with bases I’ll take them. Pm sent ...

    If they come with bases I’ll take them. Pm sent


    Sent from my iPhone using Tapatalk
  9. Replies
    2
    Views
    1,352

    Ipilot question

    When i pilot is going to a marked waypoint, is it using the location of the trolling motor or the transducer/unit of the humminbird? For example, if i tell the ipilot to navigate to a way point and...
  10. Replies
    6
    Views
    5,408

    Brush Piles in Current

    I have placed bamboo crappie condos on my local lake but they keep disappearing. They generate a lot of water and the lake is basically a river with dams on each end. I assume the current is...
  11. Thread: LAKE CATHERINE

    by nware14
    Replies
    8
    Views
    4,005

    Agree with slack line. Not the best crappie lake...

    Agree with slack line. Not the best crappie lake but a short drive to Hamilton or ouachita would be your best bet


    Sent from my iPhone using Tapatalk
  12. Replies
    21
    Views
    7,562

    G3 Boat - Anyone Got One?

    I picked up a used one a couple months ago. I think it’s an 07. No complaints so far but haven’t had it out much. I’m sure there are better boats but it gets the job done.


    Sent from my iPhone...
  13. Replies
    14
    Views
    2,797

    Should I trust an Oiler?

    Just got my hands on a new to me 2007 Yamaha 90hp two stroke that is oil injected. Should I leave it factory or take it off and mix it myself?


    Sent from my iPhone using Tapatalk
  14. Replies
    4
    Views
    1,387

    Thanks guys

    Thanks guys
  15. Replies
    4
    Views
    1,387

    WTB locking pin for minnkota quick relase 21

    Someone tried to steal my trolling motor but did a poor job. Now I am without the U shaped pin for my MKA-21 quick release mount. If anyone has one laying around or knows where I can find one it...
  16. Replies
    15
    Views
    3,655

    Zika virus?

    Zika virus?
  17. Replies
    8
    Views
    1,993

    I have a double pedastal seat set up on my 1546....

    I have a double pedastal seat set up on my 1546. Its definitely tight but we make it work. I usually dont run more than 6 poles at a time though.
  18. Replies
    9
    Views
    1,693

    I'll try the sanding thanks for all the help. The...

    I'll try the sanding thanks for all the help. The seat seems to just be brass and the diagrams I've found don't really show much about the seat but thanks again!
  19. Replies
    9
    Views
    1,693

    I take the bottom bowl off and the float and the...

    I take the bottom bowl off and the float and the little lever falls down but the needle stays in the seat
  20. Replies
    9
    Views
    1,693

    Thanks for the reply. I have replaced the needle...

    Thanks for the reply. I have replaced the needle before and I have cleaned it with similar carb spray with the same sticking needle result
  21. Replies
    9
    Views
    1,693

    1990 Mercury 25hp Carb

    I have had problems with the motor running fine and then just not wanting to start sometimes. If you squirt gas in the carb it will idle for a few seconds. Ive taken the carb off and the needle is...
  22. Replies
    16
    Views
    3,667

    153005

    153005
  23. Replies
    16
    Views
    3,667

    I spider rig from a 1546ds triton. I bent some...

    I spider rig from a 1546ds triton. I bent some metal where it would rest on the upper part of the front deck and attached it to to t-rail/track. I had a piping flange welded to the metal and made...
  24. Thread: Piney?

    by nware14
    Replies
    9
    Views
    1,113

    Buddy fished there this weekend and didn't do any...

    Buddy fished there this weekend and didn't do any good
  25. Replies
    10
    Views
    2,031

    Pinnacles are way more flimsy than the west...

    Pinnacles are way more flimsy than the west points. I ordered pinnacles an sent them straight back.
  26. Replies
    15
    Views
    2,491

    409 works pretty good

    409 works pretty good
  27. Replies
    8
    Views
    2,110

    I fish the big D literally every weekend and will...

    I fish the big D literally every weekend and will be out there this one too. Past two weeks have been bad slow. Went with a buddy to the shoal area to help him scout for a bass tourney and didn't see...
  28. Replies
    14
    Views
    1,872

    I have a 9 inch stiff blade and I love it. Had it...

    I have a 9 inch stiff blade and I love it. Had it for about a year. I do struggle filleting the skin off tho.
  29. Replies
    13
    Views
    4,621

    Fine by me I'm gonna plant it in an overgrown...

    Fine by me I'm gonna plant it in an overgrown area. I was just wondering how long before it was tall enough to be used.
  30. Replies
    13
    Views
    4,621

    Bamboo Gurus...

    I am wanting to start growing some cane/bamboo. How do you go about doing it? When can I plant? How long does it take to grow to a usable size?
    thanks
Results 1 to 30 of 95
Page 1 of 4 1 2 3 4

BACK TO TOP