Split Grip Handle placement

[kegler01]

I am starting a new build on my second crappie spinning rod . The first one I built was a 9 footer that was capable of casting down to 1/16 oz jigs . After building my first rod, using a Batson blank with Fuji KR guides and a Fuji split grip , I was encouraged enough to build an ultralight using simular componets. This time I bought a 7 foot Batson blank rated for 1/32 oz jigs Fuji KR guides and Fuji split grip . Heres the thing . I have used the split grips before and put them on to suit asthetics , the book I am using as a guide does not address split grips or rod balance . So here I am again with a blank and no real logic as to where to place these handle components . How do the rest of you determine where to place your reel seat ? Is there a formula or logic to it or do you just put it on where it looks right ? My objective is to maximize rod performance obviously . Any advice at this point would be helpful , am I making a mountain out of a mole hill here ?

[OneidaEagle]

I place them where they are needed and designed for the application.

My current project is some Walleye Planer Board Rods.

The split grips are places for proper seating while in my rods holders.

Balance is not Really needed for this application, however, they still balance nicely.

I would go for the “Looks AWESOME”
Effect, and then a balance as needed.

OE


Sent from my iPhone using Tapatalk

[skeetbum]

Read this once and thought about it some before answering. To me, balance is crucial. My thought is to basically fit the components of the reel seat and maybe tape them in place. Put the reel on and check for the balance you seek and slide it around some. Guides will add some tip weight so maybe a silicone band to hold them would also help. I use some red ones that mudhole sells. Tape would work but may be too heavy. I’ve done well so far but haven’t done many. Keep us posted.

[Spoonplugger1]

Grip length should be the same no matter what type grip you install.

[DockShootinJack]

If ya gonna go to the work of making one. It should feel the way you want it. To me good balance makes it feel like an extension of your hand

[Spoonplugger1]

When you are throwing such a small offering, my take is you need to maximize that aspect, it's already a light, sensitive rod by definition, it's lack of mass guarantees that, if you were throwing a heavier offering than my priorities would shift accordingly. But as always, it's your rod set your priorities and go for it.

[z520tom]

Most of my split grips are 12" in total lenght. I prefer all cork and turn them myself . I use all micro running guides and have no issues with balance. Don't use reel seats because they are heavier than all cork and I want the lightest rod possible. All cork handle, micro running guides, minimal thread and one coat of thread epoxy.

Sent from my SM-G960U using Crappie.com Fishing mobile app

[DockShootinJack]

Good looking rod

[skeetbum]

I agree with Jack, nice rod Tom. I’d be curious how much weight difference there would be between your style and the minimalist two piece reel seats. I like your cork work.

[Spoonplugger1]

On mine about 1/4 ounce lighter, cork is way lighter than a solid chunk of nylon and it's worlds more comfortable to fish. Think about it would you build a reel seat as you discribe and put on a hammer? Any tool? Ergonomically they suck, if they are poorly designed ergonomically can they really be more sensitive and easy on you to fish. The world and military would disagree with you.