Here is a suggestion I found on iboats.com
http://forums.iboats.com/showthread....ducer+minnkota
Printable View
Here is a suggestion I found on iboats.com
http://forums.iboats.com/showthread....ducer+minnkota
Thanks for this. That looks like a much better way than I have .
I have mind set up this way and it works good. Just remember to leave enough wire so the motor can turn freely. 180 degree both ways.
Thanks guys. this had me worried
Great Write up!
Thanks for the post. I would have been wasting my time last weekend if I hadn't seen this post.
Good idea. Thank for the post.
I did the same thing years ago but I ran the cable though a 1/2" flexible conduit and tied the bottom and top with radiator clamps to the shaft in case I hung it up. I ran the flex through the deployment handle also. I left plenty of slack so the motor would turn 360 degrees.
Hi guys. Does the cable actually hang freely - in front of the shaft, and from what I
can tell, the release latch, on the newer models needs a hole drilled big enough for the
transducer to slide thu... is that correct?
Rick.
ok thanks sir - will do!
Rick.