Well after a few days of thinking on it, then a few more getting material together. Finally got some time to build the racks. I used angle iron for the Mount to the versa track, square tubing for the up rights, and angle iron for the rod holders with a black Teflon cutting board from Amazon cut up to Mount to the angle that holds the rods. The front is just a flat piece of Cutting board 2 inches wide bolted to the angle iron for a spot to rest the rod butts. The back is another 2 inch piece of cutting board with notches to separate the rod ends to try to prevent tangles. I found a small rope tie off at Lowe’s that I mounted to hold one end of the bungee cord and the other end of the bungee just goes across the top of the rod and hooks around the end of the holders. I think they turned out good.
Attachment 395176
Attachment 395177
Attachment 395178
Attachment 395179
Attachment 395181