7 Attachment(s)
Even newer TM Brace from E-Z
Here is what you get
Attachment 69194
Here is is put together
Attachment 69196
Here is the buckle system in lock position
Attachment 69195
Here it is unbuckled
Attachment 69197
Here is the TM shaft protecting pad
Attachment 69198
This new TM brace is adjustable from 6 inches to 24 inches and has a very nice and easy to use 1 inch strap.
Locate where you want to install the TM Brace and use the supplied selftapping screw to afix it to your boat with the
strap under the milled aluminum base as shown in the pic above. If the pipe is not the correct length, cut it to fit and then
simply place it under your TM shaft, bring the strap and buckle over the shaft, hook it as shown in above pic, and tighten.
When you have it installed at the desired height, simply cut off any excess strap, but not too much where you can't get
ahold of it to tighten it. Use a lighter, or such to seal the end of the strap so it won't unravel. Cut it at an angle,
like it comes, to make insertion into the buckle easier.
Specify the height and I will cut the pipe and strap to fit.
$29.99 plus shipping...