I fount the golden egg Easter egg huntin'. So, I been looking at the CMC PT35 for to purchase. It is a real strain to lift the 15hp 4 stroke. Opinions????
Printable View
I fount the golden egg Easter egg huntin'. So, I been looking at the CMC PT35 for to purchase. It is a real strain to lift the 15hp 4 stroke. Opinions????
My shipmates on iBoats seem to like them. Its pretty rare to see any complaints about them.
i liked the one i had on my 50hp evenrude,i think if ur motor is a clamp on u have to buy an optional bracket though
I just replaced my tilt n trim motor and reservoir on my 75 hp Force motor. I went thru iboats.com and was very happy with the service that I got thru them. They will give you several options with which to go and will take them back and exchange them if they don't work. EB
They work well, I drilled holes in the pt and also clamped the top side.
Get it CP I have a unit made for a couple of years by Minkota with a40 mariner on it. Have used it for 12 or so yearsonlyway to go. If I was doing it over would have gone with CMC unit. Heavier made. Like Sparkie sad I mounted mine and drilled holes and used stainless bolts with nylon nuts. You will find the setback also gives a little more lift and speed.
hmmm thanks CP, I have been strugglin with lifting my motor and lettin it down because you have to put your fingers right in the slot where the motor comes down and I am very scared of the motor slipping and I know it would break my fingers ifn it didnt take them off. didnt really know that they made these for small motors.
maachuu