I have seen in some of the past post where some one made rod holders out of PVC pipe. Any one know where these were posted?
Printable View
I have seen in some of the past post where some one made rod holders out of PVC pipe. Any one know where these were posted?
i dunno if the pics are still there or not...if not PM NIMROD and he will be able to help you...here is the link
PVC rod holders [Archive] - Crappie.com
Here are some that I made.
http://i105.photobucket.com/albums/m...RodHolders.jpg
http://i105.photobucket.com/albums/m...odHolders3.jpg
This is what I dipped them in.
http://i105.photobucket.com/albums/m...plasticdip.jpg
I have seen them too they were made out of a 4 in. coupling cut in half with a hole in each side with one slotted to the end and directly on the bottom was a 3/8 or 5/16 slot about 2in.long around the circumference so you can adjust vertical and horizontal. Dont remember where i saw them. They did look like they would work. You could mount on a flat bar with a stand.
As I was typing that a picture showed up. I better learn how to type.
Mine were made from 6" PVC
Where can you find the "PLASTI-DIP" coating ?
I think you should be able to get the "Plastic Dip" at Home Depot or Lowe's