Minn Kota 40lb clamp screw washer replacement

Has anyone every replaced one of the cone shaped clamp screw washers. Lost one, got a couple of replacements for 99 cents, but the hole in the washer is smaller than the post it needs to slide onto. Do I drill the hole bigger, feed onto post, then somehow make the end of the post larger so the washer doesn't fall off?

watching

https://i.ebayimg.com/images/g/ZSAAA...7~/s-l1600.jpg

Cup goes on and the retainer holds it from falling off when loose. Sounds like you need the correct cup/washer and retaining clip. If you are determined to use the washer you have, drill it a little and use a small spring clip.

https://static.grainger.com/rp/s/is/...ei=160&wid=160

Thanks NCKenner, I'll see if Minn Kota can get me the correct sized washer and clip.

You'll need P/N 2011710 and P/N 2333000.
Minn Kota Transom Mount Clamp Washer (2-Pack) - Trollingmotorparts.com

Chris

Thanks Chris! parts ordered.