I wanna say I’ve seen that somewhere before probably off this site. Just can’t remember exactly.
I was loading my jig rack I have used for a while to bake a few heads to tie on and got to looking at a piece of all thread with some nuts on it and this came to mind
Has this been tried yet or has anyone suggested it
It should work for people who like to bake their jigs up right
What do you guys think
It should be cheap enough all thread and nuts are cheap
S10CHEVY LIKED above post
I wanna say I’ve seen that somewhere before probably off this site. Just can’t remember exactly.
Load that all thread up with washers with a nut on each end. Jig, couple 3 washers, jig, washers, etc....tighten the nuts up, good to go.
Copied from this site. Maybe Stumphunter or Nimrod?
2018 G3 Sportsman 17
2018 Yamaha F90 four stroke
Ultra 106sv bow/console
Livescope Terrova 24v Ionic lithium batteriesskeetbum LIKED above post
I use a toaster oven. You can hang a lot of jigs on the racks that go in them.
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
I use all-thread and nuts. been using it for years. You can place them then tighten them off and flip them so any run off goes down the hook shank. I'll post a picture in the next hour or so.
Last edited by STUMP HUNTER; 11-20-2019 at 05:13 PM.
PROUD MEMBER OF TEAM GEEZER ---------
Ascend 133X 13' - MotorGuide Xi3 & Mercury 4S10CHEVY, Brimfisher LIKED above post