Powder Coating Paint Supplier
Lots & lots of colors. So far i have not had to do anything to the red sickle hook eyes. No idea why but the translucent teal does not stick to it but is hard as nails on the lead part
Printable View
Powder Coating Paint Supplier
Lots & lots of colors. So far i have not had to do anything to the red sickle hook eyes. No idea why but the translucent teal does not stick to it but is hard as nails on the lead part
Just a few.....living proof that if i can do it...anyone can
http://i769.photobucket.com/albums/x...ps4def22da.jpg
The painted heads look great KAG, nice work. You have the plastic baits up side down, do you use them like that.
I like the translucent but I'd also like a solid in it also. What cure times were you using??
I have been using ever since it came out and I found that the heat gun for heating the jigs is the best way.I also use the fluid bed for a better finish and I bake for a harder finish.If the eyes have bake on paint just heat up a paper clip tip red hot and it will go right though it and clear the eye.If you want to powder paint spinner bait and not the hook just heat the body and not the hook.When dipping dip hook first then with a small brush brush off the hook then hang and bake...............woody
The first pictures is the flame that I use attached to 20 lb cylinder.......been using for years on same tank.
Attachment 110553
Attachment 110554
Attachment 110555
These are the finished products headed west tomorrow.
Attachment 110556
Attachment 110557
Attachment 110905
Here is a cheap idea I wanted to share about powder painting. Take your wife's cookie cooling sheet and bend it in half. I can hold over a hundred jigs and they all fit in my toaster oven.
Jighead you didn't get whacked for appropriating the wifes stuff!!!!!!:Rofl
What type of filter material are y'all using in the beds?