Thanks: 
HaHa: 
Reply With QuoteI mounted mine in the back of the boat. I ran the wire to the starting battery with a fuse.
Crappie Wall Hanger
MINNKOTA heading sensor( wiring)
Can i wire that into the 12volt line that feeds the trollen motor thats always hot or somewhere diffrent? Thanks
Super Moderator
* Crappie.com Supporter
I mounted mine in the back of the boat. I ran the wire to the starting battery with a fuse.
The love for fishing is one of the best gifts you can pass along
Crappie Wall Hanger II
Did same on back
Sent from my iPhone using Crappie.com Fishing mobile app
Super Moderator
* Crappie.com Supporter
I thought about putting it in a switch. I am certain I would forget to turn it on so it is hard wired in the battery stays on a charger maintainer while not in use so no concern off it running the battery down
The love for fishing is one of the best gifts you can pass along
Crappie.com 2K Star General
Anywhere with 12V power is fine. Stay away from the TM power cables when mounting it. Make a test run with it taped in place before you drill any holes. Better yet, don't drill holes at all. I mount my pucks with 3M Body Molding Tape.
crappiemax LIKED above post
Crappie Wall Hanger
Crappie.com Legend
I powered mine off the Master switch at the dash. Actually, I ran a wire off the master switch to a 4 circuit fuse block and use it to power my Heading Sensor, Ethernet Port, Mega Live, and Mega 360. 1 switch turns them all on/off.
HOI Crappie Club
Where family and friends come to compete for a little more than bragging rights.
Quick, someone teach me how to fish so I can win this tournament!!!
Super Moderator
* Crappie.com Supporter
Good idea
The love for fishing is one of the best gifts you can pass along
Crappie.com 2K Star General
Similar to how I do it. I added a 20A switch to a blank spot in the console which feeds a dedicated circuit to the fuse block for all of my electronics. One switch turns everything off.Originally Posted by Hanr3
