May be a bad relay. Just because it clicks does not mean its good. Try swapping them.
Nissan 50HP DFI (2003) trim goes up but will not go down. You can here both the switches click but no downward movement. Any suggestions?
"Die before you die, there is no chance after" CS Lewis
May be a bad relay. Just because it clicks does not mean its good. Try swapping them.
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
Thanks Barnacle Bill, I’ll try it.
"Die before you die, there is no chance after" CS Lewis
yes what Bill said . did that on my pontoon CMC T&T.
retired and now i will always fish
Had that happen to my 90hp Merc .... bad relays .... bought 2 new ones & swapped them out, myself. Good thing it was a pretty simple, straightforward job, as I'm not the least bit mechanically inclined.
BuckeyeCrappie LIKED above post
Where are the relays located?
hudnut thanked you for this post
2008 Merc 75 Opti. My trim switch on engine quit trimming down....up still worked. Switch is 70$ so just made do. Fast forward a few months.. I'm walking by the boat and all of a sudden I hear the PT start trimming down on the motor totor. Switch had decided to fail closed. Praises that it happened while I was off rather than at work. Pushed up on trim switch and hollered for wife to hold the up while I disconnected the battery.
Sent from my E6810 using Crappie.com Fishing mobile app
Swap the relays and you can diagnose whether it's the switch or the relays. Where I shop switches and relays are expensive and non returnable. And if it is the switch disconnect it till you replace it. Lesson learned for me
Sent from my E6810 using Crappie.com Fishing mobile app