How to build a 'lift assist for old terova?

[shuorc]

Always wanted a terova trolling motor, now that one is on my tracker find that i can't lift it and wonder what
can be made to lift it high enough to stow. any help would be greatly appreciated.--shu

[DockShootinJack]

What about a pull handle hooked to the shaft of the motor. That way you can push the toggle with your foot and pull the motor up and over the balance point? I have the same motor on my boat. I will look and see if that would make it easier.

[shuorc]

Thank you, Thank you. Took the pull rope from parts motor and tied it to the height adjust knob bolt and was able to lift the motor fine, now the carbs and it will be FISHIN TIME, Thanks again--shu

[DockShootinJack]

They make the G Force trolling motor handles that may provide a better grip also

["G"]

E-Z Poleholder on the MS board makes a handle you can clamp on it....they work great.

[Slab]

E-Z Poleholder on the MS board makes a handle you can clamp on it....they work great.

I need two of these. One for me and one for shu. Someone tell Ez my address!


Sent from my iPhone using Crappie.com

[DockShootinJack]

A photo of the product EZ makes in the thread would also be helpful. I have searched for it since G recommended it and can not find any information

[skeetbum]

The red one is by TH marine, I think. I’d like to see EZ’s product too.

[DockShootinJack]

I was refering to EZs as well. I looked for information on it today and came up with nothing

["G"]

Call E-Z..... Gene Johnson 1 601-750-3519