Thanks: 
HaHa: 
Reply With QuoteThank you very much! And for the prompt replies!!
Crappie Wall Hanger II
No. The port is cross drilled in the bottom of the carb
I'd rather be fishing.
Crappie.com 2K Star General
Super Mod and 2014 Crappie.com Man of the Year
* Crappie.com Supporter
Its fairly rare but floats can develop pin holes and get fuel inside of them and cause that problem.
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
Crappie.com 2K Star General
I did as suggested in post #6. Also checked the float for fuel in it, it was good. Put back together, no leak! Was going to try starting tonight, storms rolled in. I'm off tomorrow, will try it then.
I also replaced the water jacket gasket, curious as to how that goes.
Again, thanks to all for the replies !
Drinkin coffee, missin fish.
Crappie.com 2K Star General
Got it started this morning. Had one bolt loose, tightened that, all good. Thanks to all for the help !
Drinkin coffee, missin fish.wannabe fisherman LIKED above post
Crappie.com 2K Star General
If I can give a plug to marineengine.com. From the time I placed the order (for the water jacket gasket) till I received it, was 2 or 3 days. Standard shipping.
Drinkin coffee, missin fish.
