Reply With QuoteWhat motor?
Likes: 0
Thanks: 0
HaHa: 0
Slabmaster II
Kill switch
I have a push button kill switch but the motor still runs with it off changed button(switch) out and it still won’t kill engine. There’s a a black wire and black/yellow strip wire .what move should I make next
.
Super Mod and 2014 Crappie.com Man of the Year
* Crappie.com Supporter
What motor?
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
Slabmaster II
Super Mod and 2014 Crappie.com Man of the Year
* Crappie.com Supporter
Black wire goes to ground and the black/yellow wire goes to the switch boxes. These same wires go to the ignition switch to turn the motor off.
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
Crappie Wall Hanger II
You mentioned that you changed the switch out. There is a universal kill switch on the market that can be wired either "normally open" or "normally closed". There are 4 prongs on the back of the switch. The opposing prongs are a separate circuit. If you have attached the black and black/yellow to each of the two circuits, it will not function correctly. You will need a "normally closed" circuit that completes a circuit with the lanyard off or the button pushed.
I'd rather be fishing.
Slabmaster II
