Thanks Thanks:  0
HaHa HaHa:  0
Page 1 of 3 123 LastLast
Results 1 to 10 of 24

Thread: Deep Cycle vs Starting Batteries

  1. #1
    Join Date
    May 2014
    Location
    Ms
    Posts
    1,716
    Post Thanks / Like

    Default Deep Cycle vs Starting Batteries


    My cranking battery runs down while fishing. I have a 24 Interstate to crank my Mercury 60, run depth finders and live well. After a day of fishing the motor won't crank. I thought my radio was killing it so I disconnected it and it still happens. If I don't run the live well it will crank.
    I am going to a group 29 battery, all I have room for. Would a deep cycle be the best to keep the electronics and live well going and still be OK to crank with, since it is only a 60 hp.

  2. #2
    Cray's Avatar
    Cray is offline Crappie.com 2019 Man of Year, Supermod & Moderator of the Mechanics Forum * Crappie.com Supporter
    Join Date
    Oct 2010
    Location
    Byhalia,Mississippi
    Posts
    17,388
    Post Thanks / Like

    Default

    Yes
    Proud Member of Team Geezer
    Charlie Weaver USN/ENC 1965-1979




  3. #3
    Join Date
    Jan 2019
    Location
    Benton, KY
    Posts
    660
    Post Thanks / Like

    Default

    A deep cycle is specifically for a "deep discharge" over and over again like you are describing. A starting battery is not meant to be deeply discharged over and over again; if you deep discharge a cranking battery over and over again it simply will not last very long.

    Yes, go with the deep cycle as that's what I use with my 40 hp and livewell, lights, radio, and depth finders. I have a group 29, Everstart Marine, gives me 4 good years before it starts showing it's age....for $100 it's a bargain when you look at it as $25/year.

  4. #4
    Join Date
    Nov 2018
    Location
    Seymour,TN
    Posts
    24
    Post Thanks / Like

    Default

    Using a deep cycle battery can interfere with your charging system and the starting system. Deep cycle batteries have thin lead plates that are meant to put out a very low
    amperage over a long period of time like troling motors do. When you use one to start your motor, it pulls way too much amperage and creates heat in your starter, battery and in the wiring harness that will eventually lead to premature failure in one or all. Also a motor, like yours, with a stator and rectifier charging system are not meant to charge deep cycle batteries. The rectifier is a series of diodes (one way check valve for electricity) and resistors. The rectifier usually lets the battery over charge and causes its self to overheat and short to ground. I have a motor just like yours in my shop right now. I can text pictures if you would like to see what happens when a deep cycle is used for cranking. I recommend fixing the battery drain and switching to an Interstate 24M-XHD before you wind up spending a lot of money in repairs.

  5. #5
    Join Date
    Aug 2017
    Location
    NE AL
    Posts
    4,019
    Post Thanks / Like

    Default

    These new electronic devices, especially the Livescope, suck the juice out of a battery. I've thought about this all weekend. I think I'm going to go with a dual purpose cranking/trolling battery.

  6. #6
    Join Date
    Jun 2009
    Location
    Leslie
    Posts
    4,396
    Post Thanks / Like

    Default

    Just a thought but, are you actually charging your starting battery or are you simply relying on your motor's alternator?

    If the answer is "yes" to the second part of the question, I suspect you are using more juice than you are replacing and I suggest purchasing/installing an onboard battery charger that will charge your trolling motor batteries as well as your main battery. If however you are charging your battery, it could be as simple as you having a bad battery that will not take a full charge.
    I have OCD "Obsessive Crappie Disorder"
    Likes crappiemax, Bricks LIKED above post

  7. #7
    Join Date
    May 2014
    Location
    Ms
    Posts
    1,716
    Post Thanks / Like

    Default

    I do have a on board charger for both trolling batteries and starting battery that is plugged in as soon as I get back home. I usually only crank my motor 3-4 times on a trip. I know adding another battery for the live well and electronics would be the best choice but I was trying to get around another battery and another charger if I could. I don't want to have expensive electrical repairs either.

  8. #8
    Cray's Avatar
    Cray is offline Crappie.com 2019 Man of Year, Supermod & Moderator of the Mechanics Forum * Crappie.com Supporter
    Join Date
    Oct 2010
    Location
    Byhalia,Mississippi
    Posts
    17,388
    Post Thanks / Like

    Default

    Quote Originally Posted by deltarat View Post
    I do have a on board charger for both trolling batteries and starting battery that is plugged in as soon as I get back home. I usually only crank my motor 3-4 times on a trip. I know adding another battery for the live well and electronics would be the best choice but I was trying to get around another battery and another charger if I could. I don't want to have expensive electrical repairs either.
    I have a 50 four stroke Yamaha. I run 2 depthfinders, a 12 volt air pump and my livewell pump on a timer from the time I put it in the water until I take it out. Had a 27 on it. That one went bad after about 5 years. Replaced it with one of the Exide group 24 dual purpose batteries from academy. Haven’t had a problem going on 2 years. Good sign of a good battery is battery weight. That exide is as heavy or heavier than the 27 deep cycle it replaced. All that weight comes from the lead plates. Heavier plates means longer life.
    Proud Member of Team Geezer
    Charlie Weaver USN/ENC 1965-1979




  9. #9
    Join Date
    Nov 2018
    Location
    Seymour,TN
    Posts
    24
    Post Thanks / Like

    Default

    An easy way to check if the charging system is working is to look at the tach. The tach works off of the rectifier and stator. If the tach is not working, check the back of the tach to see if it has a good 12v supply, with the key on and a good ground. If both are good and it still doesn't work, there is a problem somewhere in the charging system.

  10. #10
    Join Date
    May 2014
    Location
    Ms
    Posts
    1,716
    Post Thanks / Like

    Default

    The tac is working as well as the volt meter. My battery only runs down when I use the livewell. The days I am not keeping any fish, I have no problems. I was must wanting to know if I went from a 24 cranking battery to a 29 deep cycle would be OK to use.

Page 1 of 3 123 LastLast

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

BACK TO TOP