buy it..install it..enjoy it
Ulterras use a Hall Effect device to count how far it has "Trimmed" down. When first deployed it trims to it's last position in memory. If you want it higher or lower from there you just push a button, it goes up or down. Unlike a scissor mount the Ulterra mount is the same regardless of length of shaft. It uses a micro switch in the base to tell the control board when the motor is fully in the stowed position. Regardless of shaft length when the motor is moving to the fully stowed position it activates the micro switch stopping the trim drive motor in the correct spot. Actually this same micro switch is the root of a lot of Ulterra problems. It and dirt dobber nests.
Slabprowler, crp4570 LIKED above post
I have a Tracker Targa 18 and it came with a 60 inch PowerDrive V2 on it. It works well so far.
Everyone has good points but it will stick out way too far from off side of boat when stowed.
Sent from my iPhone using Crappie.com Fishing mobile app
I have spent most my life fishing........the rest I wasted.
PROUD MEMBER OF TEAM GEEZER
PICO Lures Field Rep
Central Minn LIKED above post
You are right.
Buddy had an older one and it would drift off spot lock as much as 20 ft and then kick back on and almost throw him out of the boat.
He ordered a new i-Pilot board for the head and it came with new style remote. After setting it up correctly it works fine.
Sent from my iPhone using Crappie.com Fishing mobile app
FWIW, play with your boat scale setting on ipilot. Bought a new Powerdrive and was so dissatisfied first few trips using it. Couldn’t stay within 20 ft and would overcorrect constantly. I have a 1436 jon. Turned boat scale to -2 and it works much better now.
Sent from my iPhone using Crappie.com Fishing mobile app
God Bless You