Driftmaster

[Lonnie84]

This should be a pretty easy fix, have the tail end of the flange bent upright and attached with a U-bolt or drill out the hole in the flange large enough to go over the pedestal and attached a thumb screw for a lock to both sides.

[Herewego]

1/4 inch off pedestal should be enough to start threads.

Sent from my SM-G935V using Crappie.com Fishing mobile app

[Tenn Tux]

I like the way you guys think! Many thanks

[S10CHEVY]

Tenn Tux, see pictures make a difference. A lot of good ideas too.

[quikcarl61]

If you know someone with a lathe, they could chuck it up and remove about another 1/4" from the bottom of the pedestal, at the bigger part of the shaft this should give you enough clearance.

[Tenn Tux]

you are right S10. I thought I would get some ideas...pictures did the trick. Thanks again for the advice and thanks "G" for showing me the way to post. I believe the crowfoot is a good product. It really blows setting it all up and not being able to use it. I had bought new depth counter reels and rods all ready to do some trolling with newly purchased Picos and Bandits last summer. Major let down. I'm truly surprised that "Driftmaster" did not have more input...ideas...etc. After all, it was designed by them. I mean no disrespect...a little disappointed. Kind of like a kid with a Christmas present and cant play with it. Great forum. Thanks to all.

[Tenn Tux]

Thanks for the pictures Lonnie. Great ideas