Anyone use a underspin mold as a normal jig head
Hard choice but choosing only one would probably be the Freestyle mold since it takes a plastic keeper insert or you can pour them without and heads go from 1/32 on up and you can add eyes which I like on my jigs.
GrumpyLoomis LIKED above postTWFairweather thanked you for this post
TWFairweather LIKED above post
At got these ones off Amazon early last year. 1st time doing that. Finally got around to using some.
Fishing Lure Eyes 2196pcs 3-6mm... https://www.amazon.com/dp/B08TMLRF5C...p_mob_ap_share
TWFairweather, SuperDave336 LIKED above post
I bought the Randy Howell Herring Head under spin mold from Do-It. Then I bought the exact accessory wire forms that fit, also made by Do-It. Then discovered that the wire simply falls out after pouring. If you want to pour minnow heads without the under spin wire just buy this mold and use it exactly as directed, add the wire anyways, as it will not matter if you add the wire or not, you ain’t gonna get no under spin jig heads.
I modified it to where I can make a fine under spin. One that is solid and does not fall out on the floor. Easier and cheaper than using the silly wire forms they charge so much money for.
My best jig this year is unknown as I have made so many styles I can’t keep up. The addiction has me fully engaged in creating newer and better jigs. Each time they seem to be better too, but then soon after another one suddenly becomes better. LOL
Maybe they will bite this one……TWFairweather LIKED above post
Hilts 1/16 for tubes/plastics. Pony head 1/16 no collar for hand tied.
Fish like your hungry!TWFairweather LIKED above post