Likes: 
HaHa: 
Reply With QuoteHey DAN, check these out. I have one for my LVS32 and love it Just an option
0 DEG GARMIN LIVESCOPE PANOPTIX MOUNTS AND ADAPTERS FISHOBSESSED
– FishObsessed
Slabmaster II
Which LV34 Transducer Bracket
I’m not sure which LV34 Transducer bracket to install on my transducer pole.
- One has a single white mark
- The other has 3 white marks
The transducer will be mounted on the port side of the transducer pole.
Thanks,
Dan
Super Moderator
* Crappie.com Supporter * Member Sponsor
Hey DAN, check these out. I have one for my LVS32 and love it Just an option
0 DEG GARMIN LIVESCOPE PANOPTIX MOUNTS AND ADAPTERS FISHOBSESSED
– FishObsessed
“If your too busy to fish, you’re too busy!” Buddy Ebsen
PROUD MEMBER OF TEAM GEEZER
(Billbob and “G” approved!)
Proud member of Tekeum’s Jigs Pro
Staff
https://heavenornot.net/
heavenornot.net
Slabmaster II
Thanks BuchEye, but I’m running a pole mounted transducer. I would have thought that the single white mark would sit on one side of the mount and the triple white mark on the other, because the both have opposite degree offsets. But the 1 mark vs 3 puts that thinking into question.
Trophy King II
Mine is mounted on a transducer pole on the starboard side. Not sure if this will help you any or not
Sent from my SM-G892A using Crappie.com mobile app
Slabmaster II
Bbrown, what are the 3 white marks for?
Sure like the double protection for the wire. What did you use for the outer tubing? Looks like a rod sock.
Super Moderator
* Crappie.com Supporter * Member Sponsor
My bad DD
The 3 white marks are for positions (views). Downward and Fwd.
See page 11 and 12.
https://manuals.plus/garmin/livescop...ual.pdf#page13
“If your too busy to fish, you’re too busy!” Buddy Ebsen
PROUD MEMBER OF TEAM GEEZER
(Billbob and “G” approved!)
Proud member of Tekeum’s Jigs Pro
Staff
https://heavenornot.net/
heavenornot.net
Trophy King II
The marks are just to ensure that the transducer is at the proper angle for forward facing mode and the center mark is for down scan mode. The mount is just a zero degree pole mount from Garmin (part number 010-13228-03) that can be purchased for around 25-30 bucks. I ran the transducer cable inside some cheap automotive conduit, then wrapped the whole thing In some braided cable sleeve, which you are correct, can also be used to make rod socks.
Sent from my SM-G892A using Crappie.com mobile app
BuckeyeCrappie thanked you for this post
Slabmaster II
Thanks BuckEye. The manual is exactly what I needed. It would have been nic3 if Garmin would have encluded a zero degree mount for 5hose with a pole mount.
