That makes sense. My Helix has that power cord and it has no issues.
Sent from my SM-G900V using Crappie.com Fishing mobile app
That makes sense. My Helix has that power cord and it has no issues.
Sent from my SM-G900V using Crappie.com Fishing mobile app
After looking ferrite rings up, there's about 9000 different kinds. Any particular one to get? Rings, clamp on, megahertz? Do they all just do the same thing or are the specialized?
Sent from my SM-G900V using Crappie.com Fishing mobile app
Just call HB, bet they’ll take care of you.
Sent from my iPhone using Crappie.com Fishing mobile app
Proud Member of Team Geezer!Cray LIKED above post
Humminbird is out of stock. Story of my life
Sent from my SM-G900V using Crappie.com Fishing mobile app
Heres some used ones forsale
LOTS of Cables/Accessories (Humminbird, Lowrance, NMEA 2000)
Sent from my SM-S907VL using Tapatalk
Pithon thanked you for this post
And as luck would have it, go to radio shack and pick up ring, go home put it on and unit won't come on. Take ring off still won't come on. Bang bang bang my head. Think my unit has called it quits. Even hooked it up to my power cord from my Helix and it still didn't come on. Welcome to my life.
Sent from my SM-G900V using Crappie.com Fishing mobile app
Narrowed this problem down a little more but I'm still stuck. Got ferrite ring cord from humminbird and still didn't fix problem. Narrowed it down to the transducer. Tried 2 different transducers and they are both doing the same thing. Have the cord away from the whole unit but when I touch the cord to the motor housing or even put the clamp against the housing in getting interference.
Put the cord in a rubber hose and wrapped the motor housing in a rubber innertube that I cut into a long strip and then clamped the transducer to the housing. Still making rf noise on my screen.
I can hold my transducer an eighth on an inch away and it will stop as long as nothing is touching the housing. Same with the cord. But I can touch the bottom fin with the transducer and it's ok. Changed out the armature in the motor, same thing. Even tried rotating the housing just a little and same thing.
Any thing else that anybody know of?
Sent from my SM-G900V using Crappie.com Fishing mobile app