Likes Likes:  1
Thanks Thanks:  1
HaHa HaHa:  0
Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: New terrova transducer help

  1. 10-06-2018, 08:08 AM #11
    riverrat85
    riverrat85 is offline Slabmaster
    Join Date
    Feb 2011
    Location
    illinois
    Posts
    96
    Post Thanks / Like
    Thread Starter

    Default


    Quote Originally Posted by Zander70 View Post
    I researched this for a few months and tried a few different things and finally found this to work best for me.

    cornfieldcrappiegear | Product Page
    Thats what i ended up going with as well. Really happy with it
    Reply With Quote Reply With Quote
  2. 10-06-2018, 11:05 AM #12
    minnowtime
    minnowtime is offline Crappie Wall Hanger II
    Join Date
    Sep 2007
    Location
    Broken Arrow, Ok
    Posts
    599
    Post Thanks / Like

    Default

    I mounted my transducer on bottom of motor with transducer saver. Used a 1/4" clear plastic water line split down side and put transducer cable inside for protection. Used 1/16" x 1 1/2" flat alum strap around shaft above depth stop knob use bolt to clamp it to shaft loose enough to turn . Let it extend out about 8" and zip tie hose with cable inside to end of bracket. You need slick in cord and bracket to turn when using spot lock. Just need to keep eye on cable when deploying. Very little cost and time, bought parts at Lowes.
    Reply With Quote Reply With Quote
  3. 02-02-2019, 09:26 AM #13
    Cs3
    Cs3 is offline
    Join Date
    Feb 2019
    Location
    GLADEWATER
    Posts
    1
    Post Thanks / Like

    Default

    I was determined to figure out how to route my mega through the terrova with lift assist and believed I figured it out. Remove the lift assist it's simple start at the bottom collar just wear leather gloves let tape slide up in the paddle looking thing at top of tm pull all the bolts from paddle and pull out spring coil. Mine didn't spring out like everyone is thinking they will. Disassemble head unit, slide shaft out and to install mega or lss2 lowrance ducer you will have to carefully use a die grinder or wider dremel bit to grind down into slot so wire does not stick out but dont go too deep. It is a pita but to me worth it. I have been contemplating doing this for months sitting on this solix 10 and finally said to heck with it and took the chance.
    Last edited by Barnacle Bill; 02-02-2019 at 09:50 AM.
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

BACK TO TOP