This was all while just using the trolling motor. Don't have my outboard running yet.
I installed my FF this afternoon and tried it out this evening, to start with it was showing a lot of noise right by the surface but the longer I was out the more cluttered the screen got. I turned the sensitivity down some, but still had a lot of noise between the surface and the bottom. Any ideas. I will get a picture of the mount on the transducer tomorrow. but here is the screen.
This was all while just using the trolling motor. Don't have my outboard running yet.
Are you running the trolling motor and the FF/DF on the same battery? If so, that is likely where your noise is coming from. I have a 7AH Gel Cell on which I run my DF/FFs. It will run either of my finders all day without a recharge.
Clint
Far West Kentucky
Old enough to know better and way too old to care!
took the wife out for mothers day fishing trip, i coiled up the extra transducer wire before we hit the water. FF worked a lot better today.
Clint LIKED above post