The two ears with the slots on top of the transducer that the clamp passes through. I don't have my boat here right now to take pictures. It's getting winterized.
Printable View
I have used a 2 part epoxy made by LocTite for plastic to repair some transducer mounts. If you have all the parts, just take your time and follow instructions. Then I would spring for a Transducer shield and saver to fit yours and install it. Yes you could used just the 2d transducer in motor but you lose your Di.
Thank you to all that contributed to this post. About 1 1/2 hours to take apart, cut 10 inches off of shaft, run DI transducer and reassemble. Now I can't wait to get out on the water!
I too want to thank the original poster and subsequent posters. I mounted a compact SI transducer on my Terrova about 2 months ago and it worked out perfect. I went the black RTV route and put the cable in the middle of the shaft notch. Took 3-4 days for the RTV to set-up and harden properly, 40-50 degree temps in the garage. She read great, and deploys/retrieves great as well.
thanks!
Has anyone mounted a Transducer to the Newer Terrova with the Lift Assist?? If so, can you please post pics and how you did it. Thank you.
I can but I am not allowed to sell on here CP might shoot me. PM sent
Thank you, sir. May have to go this route.
Just installed a MK Terrova on my boat and used the transducer mounting kit from Cornfield Crappie Gear. Excellent product and easy to install. I? highly recommend it!
Sent from my iPhone using Crappie.com Fishing mobile app
Do you have some pictures you can post on your install? Thank you.