Thanks: 
HaHa: 
Reply With QuoteTake battery out and rub it then reinsert it and see if that will help. Worked for me.
Crappie Wall Hanger II
112 Terrova remote problem
I have a 112# Terrova remote that has stopped working. Unit is less than 6 months old. I had been using it and turned it off before motoring to a different spot. When I was ready to use it again it would not power up. It had a full charge on it. Is there a way to reset the remote? I was hoping that I would not have to send it back in to Minnkota.
Thanks
Paul -- Team Crappie Stalker
Crappie Wall Hanger II
Take battery out and rub it then reinsert it and see if that will help. Worked for me.
Trump is like the guy that comes on the playground and beats up on the guys that's been pushing you around for the last 30 or 40 years.
TurboDan LIKED above post
Crappie Wall Hanger II
Thanks Ricky for the suggestion
I have tried that but still no luck
Paul -- Team Crappie Stalker
Crappie Wall Hanger II
If you have the new version of the I-Pilot remote you may not need the "N" on the battery number. I opened mine up to change the battery and the factory battery did not have the "N" number.Originally Posted by frontierman
As I found out later they must have changed the battery holder on the new model and the "N" is not needed. This makes it a lot easier to find a new battery. Walmart had the battery that fit mine.
You might want to check to be sure that it is seated all the way down too.
Lund Rebel XL 1625 Merc 60 4 stroke
Yamaha T8 Lowrance HDS 5
Minn Kota 70lb I Pilot 60"
Crappie Wall Hanger II
I have a Terrova 80lb with iPilot that is just over a year old and have no complaints, it works great. I am planning on upgrading my electronics and want to move up to the Link system. Looking at the prices, $800 to get the new head/remote onto my current TM versus $1700ish for a completely new setup. Recommendations? Any known issues in swapping heads? Thanks!
A man remembered never dies.
Crappie.com Legend - 2017 Man Of The Year
I upgraded from the ipilot to the link. Easy to do and not 1 problem!
Proud Member of Team Geezer!
Crappie.com 2019 Man of Year, Supermod & Moderator of the Mechanics Forum
* Crappie.com Supporter
You could sell your old unit off the Terrova and recoup some of the money spent on link set up.
Proud Member of Team Geezer
Charlie Weaver USN/ENC 1965-1979
Crappie Wall Hanger II
When installing the terrova and you cannot reach some or all the area under the deck,
what do you use to attach the mounting base?
Super Mod and 2014 Crappie.com Man of the Year
* Crappie.com Supporter
New trolling motors use to come with a set of well nuts. I can't remember if they still do or not.
Shop Standard (SAE) Well Nuts at Lowes.com#!
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
Crappie Wall Hanger
I never liked well nuts because they deteriorate over time. Even sucks more when you try to remove them.
Posting Permissions
