Thread: Anybody make a soft plastic weedguard mold?

I thought about taking either some high heat plastic & drilling a 5/8" opening & then drilling on down with either an 1/8 or 3/16" drill bit to inject clear plastisiol into. If i had aluminium i'd use it instead but i'll figure something out since it would be for my own use exclusively. Any suggestions on doing this? Thanks

Not fancy but i got it figured out & it will work for sure. Done ike i said & bolted & clamped 2 pieces of h d p e plastic together then drilled 4 cavities into them. Then took an index bit & drilled down just deep enough for injector to fit perfectly into. Then drilled the 4 weedguard cavities on down deeper. Had to do a little touch up with a utility knife but shot it & it worked great. Now i'll just have to insert jig eye through one end & pinch off after inserting hook. Of course after figuring out a lentgh that will work across the board i'll just cut to length & bag some up to have when needed. Easy peezy & shot in clear plastic will work great.