I have an uno injection system. Perhaps next December I will graduate to a dos injector.
Mike
I know many of you beginners have problems using the dual injector the main problem guys is to keep the temperature equal in each of your Pyrex cups you could run it one or 2° off but keep it equal I run mine about 325 to 350 you can go lower but just remember to keep the temperature equal make sure everything is equal you can go down in temperature but just make sure that you keep it equal when you were shooting the dual injector. Make sure everything is also warm including your molds in your injector.
I have an uno injection system. Perhaps next December I will graduate to a dos injector.
Mike
Aquatic Species Removal Engineer.
May God be with you. Keep CALM and STAY ANCHORED with your faith.
I have just a basic one tube injector Bob. Uno is Spanish for one. Dos is Spanish for dual dor two.
Mike
Aquatic Species Removal Engineer.
May God be with you. Keep CALM and STAY ANCHORED with your faith.
snake River LIKED above post
Still experiencing problems with dual injecting even with equal Temps and heated molds and injectors some shoots I get a couple baits with some bleed over is this normal or am I missing something I'm using pigments
S10CHEVY LIKED above post
I see them dual injectors sure are tricky just gotta keep working at It I suppose
roostertail I know this is opposite of what everybody says but give this a try. Cool plastisol down to 310 to 315 and use a cold injector and cold mold...
https://Slabanatorjigs.com/
AND Slab-A-nator crappie jigs on facebook
CRAPPIE USA CLASSIC WINNER 2018
Finally getting somewhere appreciate everyones help it was a heating issue had to change a setting on my temp gun