Reply With QuoteNope!
Thought about it ...I did on the 1st molds I did, but have been having such good luck ...Kinda like the Fiba fuse Just fazed it out
Thanks: 0
HaHa: 0
Crappie Wall Hanger
Ever consider touching the mold halves with a light sanding (wet/dry)on a perfectly flat surface for a tighter seal ?Originally Posted by HOODLUM
billygee :rolleyes:
Trophy King II
Thought about it ...I did on the 1st molds I did, but have been having such good luck ...Kinda like the Fiba fuse Just fazed it out
Trophy King II
These little bugger's are proving to be a total pain...I think I'm going to eliminate the front legs altogether, and only keep the 2 sets of hind legs and maybe fill the feet too...
Altho I should prolly drill a couple of clamping holes and clamp it
Crappie.com 2K Star General
It's really tough to duplicate the fine details with plaster, even with a 2-part mold, lures that require and injection mold. But good try!
https://www.youtube.com/watch?v=vfsGWBV5eNw
But you have given me an idea......
Other than the legs being attached using a candle flame,
I might be able to use my usual floor tile technique used to pour & cut as I do for my minnow grub:
snake River LIKED above post
Trophy King II
Spoonminnow,
Thanks for the vid!
I just need to drill the bolt holes to put better pressure on the top half!
