Thanks: 
HaHa: 
Reply With QuoteNice!!
Crappie.com 1K Star General
this one....
...just flips my switch.
The bluegill plastic that tops this has a very, very tiny bit of turquoise colorant in it and I do mean miniscule. There is uv enhancer in there too to help it out. The picture does noting to show what these bait look like in the hand.
Crappie.com Legend
Nice!!
Crappie.com 2010 Man of the Year
* Crappie.com Supporter * Member Sponsor
nice-looking bait.
www.bobsjigs.com
Crappie.com 1K Star General
Here's a 4" ring worm in the same colors. I did a dozen of these for my walleye bucket.
S10CHEVY LIKED above post
Slabmaster II
Very nice i like that color
Trophy King II
again Tom spectacular Dave
Crappie Wall Hanger
CTom
Curiosity question, been studying the chartreuse tail; is this shot onto the body or attached by bonding then clear dipped to the tail ?
billygee :rolleyes:
Crappie.com 1K Star General
When I want tails for a particular mold I'll sit and shoot maybe 50 to 60 molds-full of chartreuse baits to use for the tails. I trim the tails off the baits but I trim them leaving about 1/2 of the body still attached. When I want to shoot a few baits using the tails for that mold I simply count out how many I am going to do and then cut the excess body plastic off so the weld is on a fresh cut, not on an old cut. The baits will exude an oil in storage and that oil messes with the welding process and that is why I store the tails a little "long". When I have the tail cut to usable length I slip them back into the mold and then inject the second color. I usually jack up the injection temperature of the second plastic by about 10 degrees, shooting anywhere from 340 to 360 degrees and when the injector rod stops I hold some light pressure for about 8 to 10 seconds. This second color also gets a dose of stabilizer to protect the plastic with the extra heat. The extra heat and the pressure help assure a solid weld. The only time I dip a bait in clear is to seal eyes. I don't like the appearance of a bait that has a partial dip stopped half way thru the body so any that get an eye dip get it to where the tail starts, except for frogs and lizards and those I make the exception to this rule and partial dip them.
When I have time to burn I sit and shoot tail baits, as I call them, using the molds that I use tail colors on. This basically helps me not have to take time to do this when I want to make time count. I often have 12-15 gallon bags of just tail stock for several different molds hanging in my component closet at a time. My most common tail color is the chartreuse but I do the same thing with hot pink and fluorescent orange too, just not to the extent I do chartreuse.
