SLABSAUCE Crappie Attractant |
  • Line changing tip

    Tired of the cheap store bought line strippers that never work right. I bought a set of hard plastic shot classes at WalMart. I drilled a hole bottom center of each one and bolted them together with a 1/4 by three bolt and a wing nut. Chucked it up in my drill.....very fast works great. To remove line from the tool.....just spin the wing nut off and pull the shot glasses apart....line will slip right off.

    This article was originally published in forum thread: Line changing tip started by "G" View original post
    Comments 11 Comments
    1. DaveB40's Avatar
      DaveB40 -
      Thanx for the tip! I was beginning to wonder if there was an easier way to
      strip line. Using my Berkley winder is no joy. Thanx for posting. Dave
    1. scrat's Avatar
      scrat -
      Wow! Great idea. Thanks for sharing the tip.
    1. brucec's Avatar
      brucec -
      Cool
    1. skeetbum's Avatar
      skeetbum -
      Good idea G. You get a dewey button for this one.
    1. Abu65's Avatar
      Abu65 -
      I've been using a cordless drill for a while. However I always taped the line to a broken arrow shaft etc. and I could never remove the line so I had to throw the whole thing away. I do 6 or 8 of my catfish rigs at the same time. I lay the rods across my boat and take off. This is a great Idea for a way to remove the line from your stripper device. Awesome thanks for sharing.
    1. SeaRay's Avatar
      SeaRay -
      This is a great idea. Thanks for sharing. One enhancement I may make is to use a short piece of threaded rod with a regular nut on the drill side and the wing nut on the outer side with only the minimum thread needed to tighten it down . Would speed up spinning the wing nut off since the thread is much shorter.
      Once again, a great tip and I already have some of those cups.
    1. Billbob's Avatar
      Billbob -
      great tip
    1. Alphahawk's Avatar
      Alphahawk -
      Now that's a great idea.

      Regards
    1. deltarat's Avatar
      deltarat -
      I made one of those and works great.
    1. Anchor Man's Avatar
      Anchor Man -
      Good idea, thanks for sharing.
    1. tchill43's Avatar
      tchill43 -
      i can make one of those. Thanks for the tip.
  • Activity Stream

    thaDudeAbides
    thaDudeAbides replied to a thread DAY ONE RESULTS ? in Main Crappie Fishing Forum
    Today, 02:12 PM
    SuperDave336
    SuperDave336 replied to a thread Welcome Monra in For Newbies
    Today, 02:02 PM
    GoFish88
    GoFish88 replied to a thread I think it'll work in Louisiana
    Today, 02:02 PM
    1989loweprojon
    1989loweprojon replied to a thread High Rock Saturday in North Carolina
    Today, 02:01 PM
    BroKenneth
    Cray
    Cray replied to a thread Happy Birthday HookOne in Off Topic in Mississippi
    Today, 01:43 PM
    BarryG
    BarryG replied to a thread Happy Birthday N2Crappie in Missouri Off Topic
    Today, 01:30 PM
    BarryG
    BarryG replied to a thread Welcome Monra in For Newbies
    Today, 01:29 PM

BACK TO TOP