Thread: '87 Skeeter Strada F120 Rehabilitation

I can’t tell enough about the sealant from the pictures to make a recommendation. I’m assuming the black “stuff” is what you’re wanting to remove?

i have no idea what they use to bond the two surfaces. Is it pliable or rigid?

FurFlyin - yes, wanting to remove the black "stuff". Hoping someone has a magic elixer !

Is it hard like epoxy or soft like silicone?

Soft like silicone. Is it a black silicone?

Originally Posted by skunked again

Soft like silicone. Is it a black silicone?

I would think so. A razor scraper would get most of it off

I'll try that , thank you!

I was just looking at the boat. Found an old cooler laying around, it's an ugly one, never gets used. Around a 24-30 quart, getting a game plan on how to incorporate it.
Also, getting a feel for how I want to install some conduit, between the hull and gunwale, both sides. For current and future wiring.
I'm planning on going to a local boat show, next Friday. Going solely to look at how boats are wired (location of fuse block), switches, layout, etc.
I'm starting to feel excited !

I tried a scraper on it. It works, gonna take a while.

Disclaimer.... this could damage the finish.

You could try a wire brush on a drill or a nylon cup brush.