doing a great job jafacman.
Started with this for $25 and another for $50 then put them together and after a lot of work I got this with 121lbs per cylinder I might add :D All this for less than $130 finished Cool aint it for an old 69
doing a great job jafacman.
Got crappie?:D
Wow Joe, great job breathing new life into that motor,is that a Evinrude 18-20?
looks good!
looks good joe
Thanks yall, but i couldn't stand it so i tore it down and did the block :D Sure is pretty, now gotta wait for the epoxy to dry i'll get pics as it goes back together
nice job
The fishing was good,it was the catching that was bad
Good job Joe, and you can paint too. What painting setup you got, I know thats not spraycan paint, is it?
Went by the lake today and not a soul on the water that I could see, looked like a few people were fishing under the bridge but that was it.
weather is rough here in atl, that high temp paint you go thtere?!?!?!:D